A two-phase generator is connected to two 90 Ω load resistors. Each coil generates 120 V ac. A common neutral line exists. How much current flows through the common neutral line?

A two-phase generator is connected to two 90 Ω load resistors. Each coil generates 120 V ac. A common neutral line exists. How much current flows through the common neutral line? Correct Answer 1.77 A

Bissoy MCQ

Related Questions

A three-phase generator is connected to three 90 Ω load resistors. Each coil generates 120 V ac. A common neutral line exists. How much current flows through the common neutral line?
A certain amount of current flows through a ring shaped coil with fixed number of turns. How does the magnetic induction B varies inside the coil if an iron core is threaded into coil without dimensional change of coil?
একটি স্টেপ আপ ট্রান্সফরমারে, গৌণ কুণ্ডলীর পাকসংখ্যা মুখ্য কুন্ডলীর পাকসংখ্যার দ্বিগুণ। যদি মূখ্য কুন্ডলীকে কোন পরিবর্তী বিদ্যুৎ লাইনের সাথে সংযুক্ত করা হয়, তাহলে মুখ্য কুণ্ডলীর তুলনায় গৌণ কুণ্ডলীতে- (In a step up transformer, the number of turns in the secondary coil is twice to that of primary coil. If you apply an alternating current in the primary coil, then in the secondary coil compared to the primary coil-)
An isolated generator connected to a turbine with its continuous maximum power of 20 MW, 50 Hz. Generator connected with two loads of 8 MW, each operate at 50 Hz.. Generator has 5% droop characteristic. If an additional load of 6 MW is added then frequency will be ___________
What is linear_congruential_engine? for some w using Mersenne Twister algorithm b) Pseudo-random number engine that generates random unsigned integers c) Pseudo-random number engine that generates random unsigned integers in the range for some w using lagged Fibonacci generator d) Pseudo-random number engine that generates random signed integers in the range for some w using Mersenne Twister algorithm
Three 10 kΩ resistors are connected in series. A 20 kΩ resistor is connected in parallel across one of the 10 kΩ resistors. The voltage source is 24 V. The total current in the circuit is
A single-phase full converter bridge, is connected to a RLE load. The source has a rms voltage of 230 V and the average load current is 10 A. Find the firing angle for which the power flows from AC source to the DC load. Consider E = 120 V, R = 0.4 Ω.
A single-phase full converter bridge, is connected to a RLE load. The source has a rms voltage of 230 V and the average load current is 10 A. Find the firing angle for which the power flows from the DC load to the AC source. Consider E = 120 V, R = 0.4 Ω, L = 2 Henry.
There is a total of 800 mA of current into four parallel resistors. The currents through three of the resistors are 40 mA, 70 mA, and 200 mA. The current through the fourth resistor is
A large circular coil of N turns and radius R carries a time varying current $$I = {I_0}\sin \left( {\omega t} \right).$$   A small circular coil of n turns and radius r(r ≪ R) is placed at the centre of the large coil such that the coils are concentric and coplanar. The induced emf in the small coil