Bissoy.com
Doctors Medicines MCQs Q&A

If brushes of a D.C. generator are moved in order to bring these brushes in magnetic neutral axis, there will be

If brushes of a D.C. generator are moved in order to bring these brushes in magnetic neutral axis, there will be Correct Answer Cross-magnetization as well as demagnetizing

Related Questions

In a D.C. generator the magnetic neutral axis coincides with the geometrical neutral axis, when
In a DC generator, when the magnetic neutral axis coincides with the geometrical neutral axis?
Consider the following statements regarding stress in beam : 1. If a member is subjected to equal and opposite couples acting in the same longitudinal planes, the member is said to be in pure bending. 2. The internal stresses developed in the beam are known as flexural stresses. 3. There is an intermediate surface known as neutral surface, at which the stress is zero. 4. An axis obtained by intersection of the neutral surface and a cross-section is known as neutral axis. Which of the above statements are correct ? 
In order to determine acidic, basic or neutral character of solutions, a student tabulated the following results after experimentation. Which of the following observations has been tabulated correctly? Case Test Solution Colour change on red litmus paper Colour change on blue litmus paper Acidic/Basic/Neutral A NaOH No change Red Acidic B Sour Milk Blue No change Neutral C Vinegar No change No change Neutral D Washing soda Blue No change Basic
In order to determine acidic, basic or neutral character of solutions, a student tabulated the following results after experimentation. Which of the following observations has been tabulated correctly? Case Test Solution Colour change on red litmus paper Colour change on blue litmus paper Acidic/Basic/Neutral A NaCl No change Red Acidic B Lime water Blue No change Neutral C Vinegar No change No change Neutral D Washing soda Blue No change Basic
Transient stability of the generator is dependent on (a) generator reactance; lower reactance decreases peak power and increases initial rotor angle. (b) how heavily the generator is loaded. (c) generator inertia; higher the inertia, slower the rate of the change of angle. (d) generator output during fault Which of the above is incorrect?
The ratio of paints and brushes in a shop is 5 : 16 respectively. The average number of paints and brushes is 840. What is the 40% of number of brushes in the shop?
Three statements are given, followed by three conclusions numbered I, II and III. Assuming the statements to be true, even if they seem to be at variance with commonly known facts, decide which of the conclusion logically follow(s) from the statements. Statements: All threads are needles. Some needles are brushes. All needles are cupboards. Conclusions: I. Some brushes are cupboards. II. All threads are cupboards. III. All brushes are threads.
In this question, two statements are given followed by two conclusions. Choose the conclusion(s) which best fit(s) logically. Statements: 1) All colours are pants. 2) All pants are brushes. Conclusions: I. Some brushes are pants. II. Some brushes are colours.
In a turbopump system using a gas generator cycle, the flame temperature in the separate gas generator where a small portion of overall propellant is burned is _________ compared to the main gas generator and its mixture ratio is _________ compared to that of the main gas generator.