Related Questions

A tailor had a number of shirt pieces to cut from some large pieces of fabric. He cut each large piece into 10 smaller pieces. He cut at the rate of 45 cuts per minute . How many large pieces would be cut in 24 minutes?
A 32
B 54
C 108
D 120
A tailor had a number of shirt pieces to cut from large piece pieces of fabric. He cut each large piece into 10 smaller pieces. He cut at the rate of 45 cuts per minute. How many large pieces would be cut in 24 minutes?
A 32
B 54
C 108
D 120
A tailor had a number of shirt pieces to cut from a roll of fabric. He cut each roll of equal length into 10 pieces. He cut at the rate of 45 cuts a minute. How many rolls would be cut in 24 minutes ?
A 32 rolls
B 54 rolls
C 108 rolls
D 120 rolls
What does the underlined word mean in the following sentence?The old man's house, badly in need of paint, was leaning to one side and had holes in the roof, but one side and had holes in the roof, but
A poorly built
B old-fashioned
C run down
D dirty
An intrinsic semiconductor has some holes in it at room temperature. What causes these holes?
A Doping
B Valence electrons
C Free electrons
D Thermal energy
E None of the above
If an aluminium pattern made from a wooden master pattern is to be used for grey iron castings, then the shrinkage allowance allowed on the wooden pattern should be
A 10 mm/m
B 16 mm/m
C 20 mm/m
D 26 mm/m
Rabindranath Tagore's 'Jana Gana Mana' has been adopted as India's National Anthem. How many stanzas of the said song were adopted?
A Third and Fourth stanza
B The whole song
C First and Second stanzav
D Only the first stanza
For cereal crops the most commonly adopted method of irrigation, is
A Free flowing method
B Check method
C Furrow method
D Sprinkling method
The Indian National Congress adopted a resolution to establish a socialistic pattern of society in :
A Avadi session in 1955.
B Bombay Session of 1953
C Calcutta session of 1957
D Nagpur session of 1959
Pick up the commonly adopted geophysical method in civil engineering from the following:
A The seismic method
B Electrical resistivity method
C Gravitational method
D Both (A) and (B) of the above

Next steps