The factor responsible for the formation of continuous chips with built up edge is

The factor responsible for the formation of continuous chips with built up edge is Correct Answer Low cutting speed and small rake angle

-continuous chip with built up edge. a built up edge (BUE) is an accumulation of material against the rake face, that seizes to the tool tip, separating it from the chip- Discontinuous chips are formed during machining of brittle metals while continuous chips with built up edge are formed during machining of ductile materials at low cutting speed
Bissoy MCQ

Related Questions

In a certain game, a large bag is filled with blue, green, purple and red chips worth 1,5,x and 11 points each, respectively. The purple chips are worth more than the red chips. A certain number of chips are then seleted from the bag, If the product of the point values of the seleted chips is 88,000, how many puriple chips were seleted?
Continuous chips with built up edge are formed during machining of
The factor responsible for the formation of discontinuous chips is
The material which on machining produces chips with built up edge is
A machine fills a bag with 7 ounces of potato chips in 3.5 seconds. At this rate, how many seconds will take the machine to fill a bag with 15 ounces of potato chips?
Computer scientists are exploring the possibility of culturing bacteria to create living chips which have digital electronic properties. What are these chips called?
A red house is built from red bricks . A blue house is built from blue bricks. A white house is built from white bricks. Then what is a greenhouse made from ?
If the length of a edge of cube X is thrice the length of an edge of cube Y, What is the ration of the volume of cube Y to the volume of cube X?
In order to avoid tearing of the plate at edge, the distance from the center line of the rivet hole to the nearest edge of the plate in terms of dia. of rivet d should be equal to
To avoid the tearing off the plate of an edge, the margin (i.e., the minimum distance from the centre of the rivet hole to the nearest edge of the plate) should be equal to