In order to achieve a specific surface finish in single point turning, the most important factor to be controlled is

In order to achieve a specific surface finish in single point turning, the most important factor to be controlled is Correct Answer Cutting speed

In order to achieve a specific surface finish in single-point turning, the most important factor to be controlled is Cutting Speed
other parameters will impact on the surface finish:
-Minimize Deflection and Chatter, Keeping Tool Rigidity Up
-Use Balanced Tooling to Reduce Vibration
-Minimize Runout
Bissoy MCQ

Related Questions

A man walks 20 m towards South.Than turning to his right he walks 30 m.Than turning to his left he walks 20 m.Again turning to his left he walks 30 m.How far is he from his starting position ?
Four men and 6 women finish a job in 8 days. while 3 men and 7 women finish it in 10 days. while 3 men and 7 women finish it in 10 days. In how many days will 10 women take to finish the work together?
Point A is 10 miles West of Point B. Point b is 30 miles North of pint C. Point C is 20 miles East of Point D. What is the distance (in miles) between Point A and Point D?
Point A is 10 km west of point B. Point B is 30 km north of point C. Point C is 20 km east of point D. What is the distance between point A and D?
Rumi and Rony can finish a task, working together, in 12 days. If Rony alone can finish that in 20 days, how many days will Rumi need to finish the task working alone ?
A drives 30 km south. Then he turns right and drives another 30 km. Turning left from here. he drives 20 km. finally turning left, he drives 30 km. How far is A from his starting position?
Point A is south of point B and point B is west point C. To which direction is point A with respect to point C ?
Point A is 10 miles west of Point B. Point B is 30 miles North of Point C. Point C is 20 miles East of Point D. what is the distance between points A and D?
In a single point tool, the angle between the surface of the flank immediately below the point and a line drawn from the point perpendicular to the base, is known as
When workers do not find their assignments challenging, they become bored and, therefore, achieve less then their potential. On the other hand, when works find their assignments too difficult, they give up and so again achieve less than what they are capable of achieving. It is, therefore, clear that no worker’s full potential will even be realized. Which one of the following is an error of reasoning contained in the argument?