Which component of an IED creates an electrical charge?

A activator
B fuse
C explosive
D power source

Correct Answer: power source

The power source such as a Battery of an IED creates an electrical charge.

 

What are IED's ::

An Improvised Explosive Device (IED) is a bomb constructed and deployed in ways other than in conventional military action. It may be constructed of conventional military explosives, such as an artillery shell, attached to a detonating mechanism. IEDs are commonly used as roadside bombs.

Bissoy MCQ
#Physics #AIEEE #Bank Exams #CAT #GATE #Analyst #Bank Clerk #Bank PO #IT Trainer

Related Questions

The component that forms the electrical connection between the rotating coil of wire in a motor and the external source of electrical energy is called the:
A rotor
B armature
C battery
D commutator
E None of the above
Which component stores an electrical charge?
A diode
B rectifier
C capacitor
D resistor
E transistor
Fugacity of a component in an ideal gas mixture is euqal to the partial pressure of that component in the mixture. The fugacity of each component in a stable homogeneous solution at contant pressure and temperature __________ as its mole fraction increases.
A Decreases
B Decreases exponentially
C Increases
D Remains constant
Relative volatility varies with the concentration of component for an ideal solution. The relative volatity of a binary mixture may be defined as the ratio of vapor pressure of component 'A' to that of component 'B', when
A Only vapor phase follows Raoult's law
B Only liquid phase obeys Dalton's law
C Liquid phase obeys Dalton's law and vapor phase obeys Raoult's law
D Vapor phase obeys Dalton's law and liquid phase obeys Raoult's law
Strain gage uses an electrical conductor wire, which when elastically stretched increases in length and reduces in diameter. Both these dimensional changes result in __________ in the electrical resistance of the wire.
A No change
B Decrease
C Increase
D Exponential decrease
To insure that everyone understands what the electrical symbols represent it is customary to include a ________ on the electrical sheet.
A List
B Part number
C Electrical legend
D Electrical layer
What table shows the electrical state of a digital circuit's output for every possible combination of electrical states in the inputs?
A Function table
B Truth table
C Routing table
D ASCII table
E None of the above
The substances which combine together to store electrical energy during the charge are called ______ materials
A active
B passive
C inert
D dielectric
In thermal-electrical analogy charge is considered analogous to
A heat flow
B reciprocal of heat flow
C reciprocal of temperature
D temperature
E none of the above
The unit of electrical charge is the
A Coulomb
B Joule
C Volt
D Watt

Next steps