Where is the condenser placed in the ignition circuit?

Where is the condenser placed in the ignition circuit? Correct Answer Distributor housing

The condenser is always mounted in the distributor housing. The condenser consists of metallic plates usually of tin foil or aluminum foil separated by thin sheets of insulating paper or mica.
Bissoy MCQ

Related Questions

Each of the questions below consists of a question and three statements numbered I, II and III given below it. You have to decide whether the data provided in the statements are sufficient to answer the question. Read all the three statements and give answer. There are six letters E, I, P, G, N and O is PIGEON the word formed after performing the following operations using these six letters only? I. O is placed fourth to the right of P. G is not placed immediately next to either P or O. II. N is placed immediately next (either left or right) to O. E is placed immediately next (either left or right) to G. III. Both I and E are placed immediately next to G. The word does not begin with N. P is not placed immediately next to E.
A steam condenser is transferring 250 k W of thermal energy at a condensing temperature of 65 degree Celsius. The cooling water enters the condenser at 20 degree Celsius with a flow rate of 7500 kg/hr. If overall heat transfer coefficient for the condenser surface is 1250 W/m2 K, what surface area is required to handle this load?
A two pass surface condenser is required to handle the exhaust from a turbine developing 15 MW with specific steam consumption of 5 kg/k W h. The quality of exhaust steam is 0.9, the condenser vacuum is 66 cm of mercury while the bar meter reads 76 cm of mercury. The condenser tubes are 28 mm inside diameter, 4 mm thick and water flows through tubes with a speed of 3 m/s and inlet temperature 20 degree Celsius. All the steam is condensed, the condensate is saturated water and temperature of cooling water at exit is 5 degree Celsius less than the condensate temperature. Assuming that overall coefficient of heat transfer is 4 k W/m2 degree, determine the mass of cooling water circulated
Which one of the following condenser matches to this description-‘This condenser is similar to the spray condenser, with the only difference that the coolant is directed to flow over a series of trays in a column’?
The condenser used in battery coil ignition circuit is connected in:
In which ignition switch position is the power supplied to ignition circuit?
The components of secondary ignition circuit include the secondary winding of ignition coil, distributor rotor, distributor cap and
Determine $${I_{\text{N}}}$$ for the circuit consisting of VS, R1, R2 and R3 shown in the given circuit.
Circuit Theorems and Conversions mcq question image
For the given circuit, find VTH for the circuit external to RL.
Circuit Theorems In Ac Analysis mcq question image
Find the Norton circuit, that is, IIN and RN, for the circuit given below.
Circuit Theorems and Conversions mcq question image