Which of the following is used as a material for insulation in the ignition coil?

Which of the following is used as a material for insulation in the ignition coil? Correct Answer Paper

The voltage difference between the adjacent turns is small, only think insulation is required and enameled wire is used. However, there is sufficient voltage drop between the layers and for this purpose, the paper is used for insulation.
Bissoy MCQ

Related Questions

একটি স্টেপ আপ ট্রান্সফরমারে, গৌণ কুণ্ডলীর পাকসংখ্যা মুখ্য কুন্ডলীর পাকসংখ্যার দ্বিগুণ। যদি মূখ্য কুন্ডলীকে কোন পরিবর্তী বিদ্যুৎ লাইনের সাথে সংযুক্ত করা হয়, তাহলে মুখ্য কুণ্ডলীর তুলনায় গৌণ কুণ্ডলীতে- (In a step up transformer, the number of turns in the secondary coil is twice to that of primary coil. If you apply an alternating current in the primary coil, then in the secondary coil compared to the primary coil-)
A hot fluid is being conveyed through a long pipe of 4 cm outer diameter and covered with 2 cm thick insulation. It is proposed to reduce the conduction heat loss to the surroundings to one-third of the present rate by further covering with same insulation. Calculate the additional thickness of insulation
Adithya peddles a stationary bicycle the pedals of which are attached to a 500 turn coil of area 11 m2. The coil rotates at half a revolution per second and it is placed in a uniform magnetic field of 20.5 T perpendicular to the axis of rotation of the coil. What is the maximum voltage generated in the coil?
In an iron cored coil the iron core is removed so that the coil becomes an air cored coil. The inductance of the coil will
A certain amount of current flows through a ring shaped coil with fixed number of turns. How does the magnetic induction B varies inside the coil if an iron core is threaded into coil without dimensional change of coil?
A current carrying coil having magnetic moment M is placed in a magnetic field B. Initially the magnetic field is perpendicular to the plane of the coil and then coil turned about an axis such that the angle between the magnetic field and the plane of the coil become zero. Then choose the correct statement.
When an electric current coil of a wattmeter is connected to the electric current path R and the voltage coil is connected between the electric current R path and the neutral side of the balanced three phase supply, it shows 10 kW. The line voltage along the phase sequence RYB is 400 V. The current drawn by the current path is 54 A. What is the new reading of the wattmeter if the voltage coil is connected between the lines B and the Y paths, even if the electric current coil is continuously present in the line R?
In a machine with coil span 9, if a coil has its one coil-side in slot 1, then its other coil-side must be in ____________
A large circular coil of N turns and radius R carries a time varying current $$I = {I_0}\sin \left( {\omega t} \right).$$   A small circular coil of n turns and radius r(r ≪ R) is placed at the centre of the large coil such that the coils are concentric and coplanar. The induced emf in the small coil
A man purchased 'X' to use it as fuel for cooking. What qualities 'X' should possess to be used as a fuel? A) Low ignition temperature and cheap.  B) High calorific values and low ignition temperature.  C) Moderate calorific value and non-toxic. D) Moderate Ignition temperature and cheap. E) Low calorific value and non-toxic.