Name the type of impeller used for agitation of low viscosity fluids, on high speeds?

Name the type of impeller used for agitation of low viscosity fluids, on high speeds? Correct Answer Propeller

Propellers are a type of impellers used for agitation of low viscosity fluids, on high speeds. They are effective in large vessels due to their persistence of flow currents. Paddles are used in slow or moderately sped vessels, whereas turbines are used over a wide range of viscosities.
Bissoy MCQ

Related Questions

Statement 1: For non-Newtonian fluids, another term called apparent viscosity is used as their viscosity changes with the change in the shear rate. Statement 2: For non-Newtonian fluids, between the transition region, the power number for non-Newtonian fluids is slightly higher than that for Newtonian fluids.
Which one of the following is the most suitable type of impeller for mixing high viscosity (viscosity > 105 cP) fluids?
What is the degree of agitation if bulk fluid velocity is 23.55 ft/min? (For 6 ft/min., degree of agitation = 1 and Degree of agitation varies from 0 to 10).
Directions : In each of the following questions a statement is given, followed by two conclusions. Give answer :

Statement : In view of the violent situation due to students' agitation the state government has decided to close down all the educational institutions in the state for two weeks with immediate effect.

Assumptions :
I. The students' agitation may subside after two weeks.
II. The students may not find a place to come further and continue agitation after the closure of the educational institutions.
Height of liquid in agitation tank is normally maintained equal to the tank diameter. However, if the tank is too tall and a large liquid hold up is desired, then two or more impellers mounted on the same shaft may be used. The clearance between the tank bottom and the bottom most impeller should be about (where, D = impeller diameter)
Statement 1: Blood is a _____ Statement 2: Thixotropic fluids are fluids whose viscosity decreases when subjected to shear stress initially but eventually with time, the viscosity increases.
Correct viscosity of furnace oil at the burner tip for proper atomisation is about 25 centistokes. To reduce the viscosity of high viscosity furnace oil (250 centistokes) to the correct atomisation viscosity (i.e. 25 cst), it should be preheated to about____°C.
Consider the following statements and choose the correct answer:
1. At low temperature, the viscosity of water increases
2. Low temperature retards the growth of the roots
3. At low temperature, viscosity of protoplasm and cell wall decreases
4. Low temperature increases the metabolic activities of the root cells
A company produces five types of shirts -- A,B,C,D and E-using cloth of three qualities -- high, medium and low , using dyes of three qualities-- high, medium and low. One shirt requires 1.5 m of cloth .The following table gives respectively : The number of shirts (of each category) produced, in thousands. The percentage distribution of cloth quality in each type of shirt, and The percentage distribution of dye quality in each type of shirt. What is the ratio of low quality dye used for C-type shirts to that used for D-type shirts ?
Read the passage carefully and choose the best answer to each question out of the four alternatives.
Eight north Indian Ocean countries, namely, Bangladesh, India, the Maldives, Myanmar, Oman, Pakistan, Sri Lanka and Thailand, were asked to contribute names so that a combined list could be compiled. Each country gave eight names and a combined list of 64 names was prepared. This list is currently in use, and all cyclones arising in the north Indian Ocean are named from this list, with one name from each country being used in turn. Almost 38 or 39 names from the list have been used up, but since many cyclones dissipate long before they hit land, their names rarely figure in the papers or other media. The names that people do know about, and remember are, naturally, those that were most destructive ones, or very recent. Aila, in 2009 is remembered with a shudder for the enormous destruction it caused in West Bengal and Bangladesh; Phaillin, also for the damage it caused when it hit the Odisha coast in 2013. Two harmless cyclones, which also might remain in peoples memory, are the more recent ones of 2014 — Hudhud, which threatened the east coast of India and Nilofar, which was expected to, but did not, devastate the western coast. The names in the cyclone list are usually words one associates with storms; words which mean water or wind or lightning in various national languages. Sometimes they are names of other things — birds or flowers or precious stones. The name Aila, contributed by the Maldives means fire, the name Phaillin from Thailand means sapphire, the name Hudhud from Oman is the name of a bird, probably the hoopoe, and the name Nilofar, given by Pakistan, is the Urdu name of the lotus or water lily. The eight names suggested by India, and which are in the list of 64, are Agni, Akaash, Bijli, Jal, Leher, Megh, Sagar and Vayu, meaning in that order, fire, sky, lightning, water, wave, cloud, sea and wind. Five of these names (that is, up to Leher) have been used so far.
For the next cyclone if it is the turn of an Indian name to be chosen, then what will be that name?