Bissoy.com
Doctors Medicines MCQs Q&A

What is the example of transport of a solute in a liquid flowing through another immiscible liquid?

What is the example of transport of a solute in a liquid flowing through another immiscible liquid? Correct Answer Liquid-liquid extraction

Liquid-liquid extraction is the example of transport of solutes in a liquid flowing through another immiscible membrane. In this, penicillin can be transferred within the filtered liquid medium which flows past another organic solvent to extract the liquids through extractor.

Related Questions

In a liquid-liquid extraction, 10 kg of a solution containing 2 kg of solute C and 8 kg of solvent A is brought into contact with 10 kg of solvent B. Solvent A and B are completely immiscible in each other whereas solute C is soluble in both the solvents. The extraction process attains equilibrium. The equilibrium relationship between the two phases is Y* = 0.9X, where Y* is the kg of C/kg of B and X is kg of C/kg of A. Choose the correct answer.
What is the example of transport of solute in a liquid flowing through a solid surface?
Estimate the interfacial solute concentration in the two liquids when the solute concentration is 45000 kg-moles/m3, interfacial solute concentration in liquid is 40000 kg-moles/m3, diffusivity is 2.5 × 10-11 m2/s and the length of the tube is 5m3 and the partition coefficient is 0.25.
I1 is the current flowing in the first mesh. I2 is the current flowing in the second mesh and I3 is the current flowing in the top mesh. If all three currents are flowing in the clockwise direction, find the value of I1, I2 and I3.
Solute mass transfer coefficient in a liquid which is flowing in a tube cannot be estimated by coating the solute over the inner wall of the tube.
What is the ratio of the mass of refrigerant flowing through condenser and mass of refrigerant flowing through the evaporator, i.e., m2 / m1? If m1 = mass of refrigerant passing through the evaporator m2 = mass of refrigerant passing through the condenser
In the following question below some statements are given followed by some conclusions. Taking the given statements to be true even if they seem to be at variance from commonly known facts, read all the conclusions and then decide which of the given conclusions logically follows the given statements. Statements: No solution is mixture. Each solvent is solute. All solute are solution. Conclusions: I. No solvent is mixture. II. Some solution is solvent. III. Some solute is mixture. 
In a wetted-wall tower, an air-H2S mixture is flowing by a film of water which is flowing as a thin film down a vertical plate. The H2S is being absorbed from the air to the water at a total pressure of 1.50 atm abs and 30oC. The value of kc of 9.567×10-4 m/s has been predicted for the gas-phase mass-transfer coefficient. At a given point the mole fraction of H2S in the liquid at the liquid-gas interface is 2.0×10-5 and pA of H2S in the gas is 0.05 atm. The Henry’s law equilibrium relation is pA(atm) = 609xA (mole fraction in liquid). Calculate the rate of absorption of H2S.
A large tank of height h is half-filled with a liquid of density ρ and other half-filled with a liquid of density 4ρ. A similar tank is half-filled with a liquid of density 2ρ and other-half filled with another liquid of density 3ρ as shown. What will be the ratio of the instantaneous velocities of discharge through a small opening at the base of the tanks? (assume that the diameter of the opening is negligible compared to the height of the liquid column in either of the tanks)
Which process of bioseparation involves the use of partitioning of a solute between two immiscible phases?