The specimen of fatigue testing must not have ___________

The specimen of fatigue testing must not have ___________ Correct Answer Notches and holes

It is necessary that the specimen being tested to determine fatigue strength not have notches and holes in it. The specimen is usually cylindrical rods that do not contain any of the above defects.
Bissoy MCQ

Related Questions

To constitute a matter of res judicata which of the following conditions must concur?
1. The matter directly and substantially in issue in the subsequent suit or issue must be the same matter which was directly and substantially in issue either actually (section 11, explanation III) or constructively (section 11, explanation IV) in the former suit
2. The former suit must have been a suit between the same parties under whom they or any of them claim. Explanation VI of Section 11 must be read with this condition
3. The parties as aforesaid must have litigated under the same title in the former suit
4. The court which decided the former suit must have been a court competent to try the subsequent suit of the suit in which such issue has been subsequently raised. Explanation II of section 11 is to be read with condition
5. The matter directly and substantially in issue in the subsequent suit must have been heard and finally decided by the court in the first suit. Explanation V of section 11 is to be read with this condition
The fatigue limit of a specimen is ___________ of its fatigue range.
A material is a fatigue tested below the fatigue limit for few millions of cycles and then retested at higher than fatigue limit. This process is known as ___________
A rock specimen of 120 mm length and 54 mm diameter is subjected to uniaxial compressive loading. Two strain gauges, one axially and other radially, are attached to the specimen. At the breaking load, if these two gauges read 0.0082 m/m and 0.0023 m/m respectively, the Poisson's ratio of the specimen is
h,J,K,L,M,N and O are the only legislators eligible to vote on Bills 1,2 and 3, each of which will be passed if at least four legislators eligible vote in favor of it. each legislator must vote on all three bills; on abstentions are possible. The following is known : *H must vote against all three bills; each of the other legislators must vote in favor of at least one bill and against at lest one bill. *j must vote against Bills 1. *O Must vote against Bills 2 and 3. * L must the same way that K dose on all three bills.*N must vote the same way that O dose on all three bills. which of the following must vote in favor of Bill 1 ?
h,J,K,L,M,N and O are the only legislators eligible to vote on Bills 1,2 and 3, each of which will be passed if at least four legislators eligible vote in favor of it. each legislator must vote on all three bills; on abstentions are possible. The following is known : *H must vote against all three bills; each of the other legislators must vote in favor of at least one bill and against at lest one bill. *j must vote against Bills 1. *O Must vote against Bills 2 and 3. * L must the same way that K dose on all three bills.*N must vote the same way that O dose on all three bills. If any bill is to be passed,which of the following must be among the legislators who vote in favor of it?
If the sample is tested for a large number of cycles below its fatigue limit and the stress is gradually increased above the fatigue limit, the true fatigue limit of material will _______
During uniaxial compressive testing of a rock specimen of diameter 54 mm and length 120 mm, the axial strain was found to be 6.5 × 10-4 mm/mm. If the Poisson's ratio of the rock is 0.3, the volumetric strain of the rock specimen in mm/mm is
A tensile specimen was deformed at a constant cross head speed of 6 mm/min. The strain rate at the start of the testing was 5 × 10-3 s-1. The initial gauge length of the specimen (in mm) was
If the size of a standard specimen for a fatigue testing machine is increased, the endurance limit for the material will