In the forging operation, the sticking friction condition occurs at which location?

In the forging operation, the sticking friction condition occurs at which location? Correct Answer In the center

In forging operation, the sticking friction condition generally happens in the center of the workpiece, this is because the material flow is restricted to the nearby region.
Bissoy MCQ

Related Questions

Which of the following is NOT true about Frictional force? A. Friction is the force which opposes the relative motion of two surfaces in contact. B. The force of friction that acts when a body is moving (sliding) on a surface is called sliding friction. C. Friction in machines wastes energy and also causes wear and tear. D. Rolling friction is much more than sliding friction, the use of ball bearings in a machine considerably reduces friction.
Consider the following statements: 1. The kinetic friction is always less than the rolling friction. 2. The kinetic friction is always equal to the rolling friction. 3. The kinetic friction is always greater than the rolling friction. Which of the following statement is correct?
While discussing about friction, a teacher gave a number of examples to explain the concept. Some of the examples where friction is useful in our day-to-day life as quoted by the teacher are given below : A. We are able to write because of friction between the tip of the pen and the paper. B. We are able to walk because of friction between our feet and the ground. C. A ball thrown vertically upwards comes back to us due to friction. D. We are able to stop a moving vehicle by applying brakes because of friction. The correct examples were
Which of the following is correct about friction? I. Rolling friction is smaller than the sliding friction II. Sliding friction is smaller than static friction 
Which of the following statements regarding laws governing the friction between dry surfaces are correct? 1. The friction force is dependent on the velocity of sliding.  2. The friction force is directly proportional to the normal force. 3. The friction force is dependent on the materials of the contact surfaces. 4. The Friction force is independent of the area of contact surfaces.
Read the given information carefully and answer the questions related to it. The eight friends A, B, C, D, E, F, G and H are sitting in the center of a circle, (they do not have to be the same). i. The location of A is the third to the right of F, who is sitting on the left of the D on the second number. ii. C and H are sitting face to face with each other. iii. None of F and C are sitting next to B. iv. B is not sitting in between H and A. v. G is seated opposite A. If the location of E is replaced by B, the location of C is shifted from place of G and the location of A is mutual, then who will be the third position on the right of C?
The sticking between the workpiece and the die occurs when the feed rate is very high, and there is a significant difference between static and dynamic friction.
Precision forging is a type of forging operation in which the metal stocks and dies are controlled very tightly.
Consider the following statements in order to perform a write operation into a specified memory location, the MDR and MAR: 1. The word to be stored into the memory location is first loaded by the CPU into MDR. 2. The address of the location into which the word is to be stored is loaded by the CPU into MAR. 3. A write signal is issued by the CPU. Which of the above statements are correct ? 
Isothermal forging is also known as cold forging operation.