Bissoy.com
Doctors Medicines MCQs Q&A

What will be the fatigue ratio of a notched specimen to an un-notched sample?

What will be the fatigue ratio of a notched specimen to an un-notched sample? Correct Answer The notched specimen will have higher fatigue ratio

The notched specimen will have lower fatigue strength, and the un-notched sample will have higher fatigue strength so that the fatigue ratio will be higher for the un-notched sample compared to the notched specimen.

Related Questions

As the temperature increases, the difference between the strength of a notched sample and un-notched sample ____________
If the sample is tested for a large number of cycles below its fatigue limit and the stress is gradually increased above the fatigue limit, the true fatigue limit of material will _______
A rock specimen of 120 mm length and 54 mm diameter is subjected to uniaxial compressive loading. Two strain gauges, one axially and other radially, are attached to the specimen. At the breaking load, if these two gauges read 0.0082 m/m and 0.0023 m/m respectively, the Poisson's ratio of the specimen is
In testing materials, only un-notched specimen of standard shape and size can be used.
The test data for Notched specimen fall near the ________________ line.
The fatigue limit of a specimen is ___________ of its fatigue range.
A material is a fatigue tested below the fatigue limit for few millions of cycles and then retested at higher than fatigue limit. This process is known as ___________
Which of the following is correct regarding the Charpy toughness test: P. The sample is held vertically as cantilever beam. Q. The sample is held horizontally as simply supported beam. R. The Notch in the sample faces the striking hammer. S. The Notch in the sample is opposite to the striking hammer.
A student was studying primate uterine thickness. She had 3 samples of uterine tissues. The thickness in mm for the samples are as follows: Sample A – 4 mm, Sample B – 10 mm, Sample C – 1 mm Given the knowledge of menstrual cycle in humans, what phases do you think each sample belongs to?
Which of the following statements are true with regards to the selection of a sample size? (i) The sample size (n) may be a fixed percentage of lot size (N). (ii) The sample size (n) may be kept constant irrespective of lot size (N). (iii) Sample size (n) can be selected at the personal whim of the inspector.