Which of the following valves is a small threaded check valve used to isolate wellbore pressure when installing on wellhead outlets?

Which of the following valves is a small threaded check valve used to isolate wellbore pressure when installing on wellhead outlets? Correct Answer Valve Removal Plug

Valve Removal Plug is a threaded valve. It can be installed on the Christmas tree. It isolates wellbore pressure when it is fitted on wellhead. It can be used to remove the gate valve used in well completion.
Bissoy MCQ

Related Questions

Which of the following heart valves are mechanical valves? i. Ball Valve ii. Autograft Valve iii. Xenograft Valve iv. Single Leaflet Valve v. Homograft Valve vi. Bi leaflet Valves
The flow capacity of a valve is calculated by the _________ Cv, the flow of water through a wide—open valve in U.S. gal/min for a pressure gradient of 1 psi. For a given nominal valve size the highest Cv is achieved with ball valves followed by (in decreasing order) gate, plug, and globe valves.
The subsurface safety valve is recently tested and the result is good. Personnel can just only shut the well in using a subsurface safety valve without installing a back pressure valve and then remove the x-mas tree.
The easiest method of physically detecting any type of scale in the wellbore is to run the caliper down the wellbore.
A 2" gate valve fitted in a pipe is replaced by a similar globe valve. Pressure drop in gate valve was Δp. For the same discharge, the pressure drop across globe valve is
In the following passage, some of the words have been left out. Read the passage carefully and select the correct answer for the given blank out of the four alternatives. When the kerosene burned, the fuel in the tank below would be __________ pressure, and __________a small circular flame would appear in the burner.The valve had to be opened to let more kerosene vapour to the burner and pumping resumed. With the increase in pressure, the burner flame would spread _________ a loud noise. To lower the flame,the valve had to be _________ opened to reduce the pressure and then tightened until the desired flame size was achieved. _________ you wanted the flame to be bigger, you had to hit the piston again. Pump stoves are still in vogue. and __________ a small circular flame
In the following passage, some of the words have been left out. Read the passage carefully and select the correct answer for the given blank out of thefour alternatives. When the kerosene burned, the fuel in the tank below would be __________ pressure, and __________ a small circular flame would appear in the burner. The valve had tobe opened to let more kerosene vapour to the burner and pumping resumed. With the increase in pressure, the burner flame would spread _________ a loud noise. Tolower the flame, the valve had to be _________ opened to reduce the pressure and then tightened until the desired flame size was achieved. _________ you wanted theflame to be bigger, you had to hit the piston again. Pump stoves are still in vogue. and __________ a small circular flame
The system of spools, adapters, and valves to control the pressure of a well in drilling and production operation is known as Wellhead Equipment.
In the following passage, some of the words have been left out. Read the passage carefully and select the correct answer for the given blank out of the four alternatives. When the kerosene burned, the fuel in the tank below would be __________ pressure, and __________a small circular flame would appear in the burner.The valve had to be opened to let more kerosene vapour to the burner and pumping resumed. With the increase in pressure, the burner flame would spread _________ a loud noise. To lower the flame,the valve had to be _________ opened to reduce the pressure and then tightened until the desired flame size was achieved. _________ you wanted the flame to be bigger, you had to hit the piston again. Pump stoves are still in vogue. below would be __________ pressure
In the following passage, some of the words have been left out. Read the passage carefully and select the correct answer for the given blank out of thefour alternatives. When the kerosene burned, the fuel in the tank below would be __________ pressure, and __________ a small circular flame would appear in the burner. The valve had tobe opened to let more kerosene vapour to the burner and pumping resumed. With the increase in pressure, the burner flame would spread _________ a loud noise. Tolower the flame, the valve had to be _________ opened to reduce the pressure and then tightened until the desired flame size was achieved. _________ you wanted theflame to be bigger, you had to hit the piston again. Pump stoves are still in vogue. below would be __________ pressure