What is the meaning of heat rejection ratio (HRR) of a condenser?

What is the meaning of heat rejection ratio (HRR) of a condenser? Correct Answer Ratio of heat rejected to the heat absorbed

The heat rejection ratio (abbreviated as HRR) is the ratio of the amount of heat rejected to the amount of heat absorbed (also known as refrigeration capacity), which is, HRR = Qc /Qe
Bissoy MCQ

Related Questions

A steam condenser is transferring 250 k W of thermal energy at a condensing temperature of 65 degree Celsius. The cooling water enters the condenser at 20 degree Celsius with a flow rate of 7500 kg/hr. If overall heat transfer coefficient for the condenser surface is 1250 W/m2 K, what surface area is required to handle this load?
A two pass surface condenser is required to handle the exhaust from a turbine developing 15 MW with specific steam consumption of 5 kg/k W h. The quality of exhaust steam is 0.9, the condenser vacuum is 66 cm of mercury while the bar meter reads 76 cm of mercury. The condenser tubes are 28 mm inside diameter, 4 mm thick and water flows through tubes with a speed of 3 m/s and inlet temperature 20 degree Celsius. All the steam is condensed, the condensate is saturated water and temperature of cooling water at exit is 5 degree Celsius less than the condensate temperature. Assuming that overall coefficient of heat transfer is 4 k W/m2 degree, determine the mass of cooling water circulated
In a surface condenser, the water flowing through a series of tubes at the rate of 200 kg/hr is heated from 15 degree Celsius to 75 degree Celsius. The steam condenses on the outside surface of tubes at atmospheric pressure and the overall heat transfer coefficient is estimated at 860 k J/m2 hr degree. Find the effectiveness of the heat exchanger. At the condensing pressure, stream has a saturation temperature 0f 100 degree Celsius and the latent heat of vaporization is 2160 k J/kg. Further, the steam is initially just saturated and the condensate leaves the exchanger without sub-cooling i.e. only latent heat of condensing steam is transferred to the water. Take specific heat of water as 4 k J/kg K
In a surface condenser, the water flowing through a series of tubes at the rate of 200 kg/hr is heated from 15 degree Celsius to 75 degree Celsius. The steam condenses on the outside surface of tubes at atmospheric pressure and the overall heat transfer coefficient is estimated at 860 k J/m2 hr degree. Find the number of transfer units of the heat exchanger. At the condensing pressure, stream has saturation temperature 0f 100 degree Celsius and the latent heat of vaporization is 2160 k J/kg. Further, the steam is initially just saturated and the condensate leaves the exchanger without sub-cooling i.e. only latent heat of condensing steam is transferred to water. Take specific heat of water as 4 k J/kg K
Which one of the following condenser matches to this description-‘This condenser is similar to the spray condenser, with the only difference that the coolant is directed to flow over a series of trays in a column’?
A Carnot heat engine receives heat at 750 K and rejects the waste heat to the environment at 300 K. The net work output of the heat engine is used to drive a Carnot refrigerator, whose COP is 6.14. If the heat removal rate from the refrigerated space is 6.6 kW, determine the rate of heat supply to the heat engine?
Find the heat removed by the condenser if the net heat out of the condenser is 25000 J and the total moles are 25.
Heat is transferred to a heat engine from a furnace at a rate of 80 MW. If the rate of waste heat rejection to a nearby river is 50 MW, determine the net power output for this heat engine.
Heat is transferred to a heat engine from a furnace at a rate of 80 MW. If the rate of waste heat rejection to a nearby river is 50 MW, determine the thermal efficiency for this heat engine.
Heat rejection in a condenser is to?