Fog formation in a condenser can occur when the temperature of the vapour-gas mixture _____________ the local saturation temperature during the condensation process.

Fog formation in a condenser can occur when the temperature of the vapour-gas mixture _____________ the local saturation temperature during the condensation process. Correct Answer Falls below

Fog formation can occur when the temperature of the vapour-gas mixture falls largely below the saturation temperature during the condensation process at that temperature and pressure. This happens when the properties of a vapour-gas mixture and the process conditions have far more heat than mass removed from the mixture.
Bissoy MCQ

Related Questions

Consider the following statements (i) If a condensing liquid does not wet a surface, then drop wise condensation will not take place on it (ii) Drop wise condensation gives a higher transfer rate than film wise condensation (iii) Reynolds number of condensing liquid is based on its mass flow rate (iv) Suitable coating or vapor additive is used to promote film wise condensation Identify the correct statement
Statement 1: Film-type condensation has a higher heat transfer co-efficient than drop-wise condensation. Statement 2: Drop-wise condensation is easier to maintain than Film-type condensation
In the question two statements are given, followed by two conclusions, I and II. You have to consider the statements to be true even if it seems to beat variance from commonly known facts. You have to decide which of the given conclusions, if any, follows from the given statements. Statement 1 : All clouds are fog.
Statement 2 : All fog are white. Conclusion I : Some white are clouds.
Conclusion II : Some fog are clouds.
In the question two statements are given, followed by two conclusions, I and II. You have to consider the statements to be true even if it seems to beat variance from commonly known facts. You have to decide which of the given conclusions, if any, follows from the given statements. Statement I: Some clouds are fog Statement II: All clouds are mist Conclusion I: Some fog are mist Conclusion II: All mist are fog
A two pass surface condenser is required to handle the exhaust from a turbine developing 15 MW with specific steam consumption of 5 kg/k W h. The quality of exhaust steam is 0.9, the condenser vacuum is 66 cm of mercury while the bar meter reads 76 cm of mercury. The condenser tubes are 28 mm inside diameter, 4 mm thick and water flows through tubes with a speed of 3 m/s and inlet temperature 20 degree Celsius. All the steam is condensed, the condensate is saturated water and temperature of cooling water at exit is 5 degree Celsius less than the condensate temperature. Assuming that overall coefficient of heat transfer is 4 k W/m2 degree, determine the mass of cooling water circulated
A steam condenser is transferring 250 k W of thermal energy at a condensing temperature of 65 degree Celsius. The cooling water enters the condenser at 20 degree Celsius with a flow rate of 7500 kg/hr. If overall heat transfer coefficient for the condenser surface is 1250 W/m2 K, what surface area is required to handle this load?
Which one of the following condenser matches to this description-‘This condenser is similar to the spray condenser, with the only difference that the coolant is directed to flow over a series of trays in a column’?
What is the value of C.O.P. of low-temperature cascade system in terms of intermediate temperature in the following diagram? If TEL and TCL = Evaporator and condenser temperatures for low-temperature cascade system TEH and TCH = Evaporator and condenser temperatures for high-temperature cascade system
What is the value of C.O.P. of high-temperature cascade system in terms of intermediate temperature in the following diagram? If TEL and TCL = Evaporator and condenser temperatures for low-temperature cascade system TEH and TCH = Evaporator and condenser temperatures for high-temperature cascade system
Reverse collector saturation is greater than Reverse saturation current because of reverse collector saturation __________