Bissoy.com
Doctors Medicines MCQs Q&A

Statement 1: Tubular bowl centrifuges can handle slurries. Statement 2: Tubular bowl centrifuges can be used for 3 phase separation.

Statement 1: Tubular bowl centrifuges can handle slurries. Statement 2: Tubular bowl centrifuges can be used for 3 phase separation. Correct Answer False, False

Tubular bowl centrifuges are used for liquid-liquid separation. Tubular bowl centrifuges can be used for 2 phase liquid-liquid separation only.

Related Questions

Tabular bowl centrifuges as compared to disk bowl centrifuges
Three friends A, B and C shared chocolates from a bowl. A took 1/3rd of the chocolates, but returned four to the bowl. B took 1/4th of what was left but returned three chocolates to the bowl. C took half of the remainder but return two back into the bowl. If the bowl has 17 chocolates left, how many chocolates were originally there in the bowl ?
The handle of a saucepan, 30 cm long and 2 cm in diameter, is subjected to 100 degree Celsius temperature during a certain cooking operation. The average unit surface conductance over the handle surface is 7.35 W/m2 degree in the kitchen air at 24 degree Celsius. The cook is likely to grasp the last 10 cm of the handle and hence the temperature in this region should not exceed 38 degree Celsius. What should be the thermal conductivity of the handle material to accomplish it? The handle may be treated as a fin insulated at the tip
Which of the following statements is/are correct with respect to a Scott-connected transformer? I. It can do 3-phase to 2-phase conversion II. It can do 2-phase to 3-phase conversion III. It can do 2-phase to 4-phase conversion IV. It can do 3-phase to 4-phase conversion
Which of the following is/are appropriate care and maintenance of centrifuges? I. Proper balancing of centrifuge tubes. II. Avoid long time exposure of the rotors to alkaline solution and acidic buffers. III. Cleaning centrifuges and rotors with coarse brushes and then wash them with distilled or de-ionized water after every run. IV. For overnight storage, the rotors are left upside down and then positioned in a safe and dry place.
A metallic hemispherical bowl is made up of steel. The total steel used in making the bowl is 342π cm3. The bowl can hold 144π cm3 water. What is the thickness (in cm) of bowl and the curved surface area (in cm2) of outer side?
2.Bowl S contains only marbles. If 14 of the marbles were removed, the bowl would be filled to  12 of its capacity. If 100 marbles were added, the bowl would be full. How many marbles are in bowl S?
Three friends, returning from a movie, stopped to eat at a restaurant. After dinner, they paid their bill and noticed a bowl of mints at the front counter. Sita took $$\frac{1}{3}$$ of the mints, but returned four because she had a monetary pang of guilt. Fatima then took $$\frac{1}{4}$$ of what was left but returned three for similar reasons. Eswari then took half of the remainder but threw two back into the bowl. The bowl had only 17 mints left when the raid was over. How many mints were originally in the bowl?
In the following question below are given some statements followed by some conclusions base on those statements. Taking the given statements to be true even if they seem to be at variance from commonly known facts. Read all the conclusions and then decide which of the given conclusion logically follows the given statements. Statements: I. No cycle is handle. II. Some handle are tyre. Conclusions: I. No tyre is cycle. II. Some tyre are handle. III. Some cycle are handle.
The network formed by resistors and capacitors for modifying the rate of change of gain and the phase shift is called a compensating network. Which of the following statements are not correct ? (A) The main purpose of a compensating network is to modify the performance of op-amp ciruit over the desired frequency range (B) There are two types of op-amps : internally compensated and externally compensated (C) 741 C is an externally compensated op-amp while 709 C is internally compensated op-amp (D) The phase lag and phase lead are most commonly used compensating networks in op-amps (E) Phase lag contributes a positive phase angle and phase lead a negative phase angle Choose the most appropriate answer from the options given below :