_________ are materials that increase the drainage rate of water from the pulp slurry on the wire.

_________ are materials that increase the drainage rate of water from the pulp slurry on the wire. Correct Answer Drainage aids

Drainage aids are materials that inc. the drainage rate of water from the pulp slurry on the wire. Almost any retention aid is opted to improve the drainage rate as fines and fillers are removed.
Bissoy MCQ

Related Questions

A telephone switchboard 100 pair cable can be made up with either enameled wire or tinned wire. There will be 400 soldered connections. The cost of soldering a connection on the enameled wire will be P 1.65 on the tinned wire, it will be P 1.15. A 100- pair cable made up with enameled wire cost P 0.55 per linear foot and those made up of tinned wire cost P 0.75 per linear foot. Determine the length of cable run in feet so that the cost of each installation would be the same.
Manure slurry, a mixture of animal waste, organic matter, and sometimes water often known simply as “slurry” in agricultural use, used as fertilizer after ageing in a slurry pit.
A slurry stream containing quartz is diverted into one litre density can. The time taken to fill up the can is measured as 5 sec. The pulp density is measured to be 1250 kg/m3. Calculate the mass flow rate of quartz within the slurry. Assuming the density of quartz is 2650kg/m3
Mechanical pulp is pulp produced by using only mechanical attrition to pulp lignocellulosic materials; no chemicals are used.
The _________ is a pressurized device that releases a uniform pulp slurry on the wire through the slice.
The _________ is a rectangular space in the heatbox where the pulp slurry is applied to the wire.
The _________ is a paper machine with a fine mesh, woven wire cloth or plastic fabric on which the pulp slurry’s deposited.
The S.P.C. techniques that are being introduced in the pulp mill would probably decrement process variability of the pulp going to the bleach plant from the pulp mill. What is the topic of discussion?
If this does not solve the problem then new S.P.C. techniques that are being introduced in the pulp mill would probably decrement process variability of the pulp going to the bleach plant from the pulp mill. What is the topic of discussion?
The floor of a siphon aqueduct needs to be designed for conditions when? i. The canal and drainage are flowing full ii. The canal is full and there is no drainage discharge iii. The canal is empty and drainage discharge is full