Control limits are ___________

Control limits are ___________ Correct Answer Limits driven by the natural variability of the process

The control limits are the limits for a quality characteristic for a process to be in-control. They are driven by the natural variability of the process.
Bissoy MCQ

Related Questions

Which of the following is/are the advantages of using a control chart for inspection? (i) A control chart indicates whether the process is in control or out of control. (ii) A control chart determines process variability. (iii) A control chart ensures product quality. (iv) Scrap or percentage reduction can be reduced by taking the necessary actions in time against the warnings indicated by control charts. (v) Control charts build up the reputation of the organization through customer’s satisfaction. (vi) The control chart can detect the unusual variations taking place in a process.
is no need of revision of control limits once calculated by the equations of control limits.
The values of control limits for the standardized c-chart are different from the control limits of the standardized p-chart.
Upper and lower boundaries of the “desired” values of y are plotted as lines. These are the _________ and _________ The average value (X, said as “X-bar”) is centred b/w the control limits. The range of the control limits, R, depends on the statistical variation of the process.
The probability of parts produced going outside the control limit is much higher in ± 3σ limits system than in ± 6σ limits system.
If “two sets of limits” approach is taken to construct a control chart, what are the outer set of limits called?
The inner limits in the “Two sets of limits” approach of the construction of control chart are called _____
Is there any relationship between specification limits and control limits of x and R charts?
Examine the following statements about span of control and identify the ones which are true?
1. More task complexity requires narrower span of control.
2. Routine tasks can have greater span of control than exceptional tasks.
3. When tasks are dissimilar, then span of control can be larger.
4. Spans of control are generally narrower at the top and broader at the bottom of the hierarchy.
In order to set drawing limits for a 'C' size architectural drawing the drafter should set the limits to ________.