Check sheet shows ___________

Check sheet shows ___________ Correct Answer Time oriented summary of defects

A check sheet is very easy way, to show the time oriented summary of defects in the number of samples taken from a lot of products from a certain process.
Bissoy MCQ

Related Questions

Ten new television shows appeared during the month of September. Five of the shows were sitcoms, three were hour-long dramas, and two were news-magazine shows. By January, only seven of these new shows were still on the air. Five of the shows that remained were sitcoms.
In the following passage, some of the words have been left out. Read the passage carefully and select the correct answer for the given blank out of the four alternatives. While language as the medium ___________ thought may be compared to air as the medium of the sun's influence, in other _____________ it is like the skin of the body; a scurvy skin shows bad blood within, and a scurvy language shows inaccurate thought ___________ a confused mind. And as a disease once fixed on the skin reacts and poisons the blood in turn as it has first been poisoned by the blood, so careless use of language __________ indulged reacts on the mind to make it permanently and increasingly _____________, illogical, and inaccurate in its thinking. shows inaccurate thought ___________ a confused mind.
The following figure shows a rolled sheet (After rolling) The region A shows the end of plate and B shows the center of plate, the nature of forces in this region will be ________
There is a clock which shows false timing ie it shows 20 minutes less for each 1 hour. If the clock shows 12 noon now how many minutes will be lost when it shows 2 pm ?
A sheet of thickness 200 mm is rolled in a roller with roll diameter of 300 mm. If the coefficient of friction between the roll and sheet is 0.1. Find the minimum number of passes required to reduce the thickness of sheet to 180 mm?
In the given diagram, the sheet of thickness h1 is reduced to thickness h2. Find the correct relation between the velocity of the sheet? Where v1 is entering velocity and v2 is exiting velocity. Assuming the width of the sheet is constant.
A sheet with an initial thickness 30 mm is rolled in two high mills with entering velocity of 5 mm/sec. If the final thickness of sheet is 15 mm find the exit velocity of rolled sheet?
A sheet with an initial thickness 30 mm is rolled in two high mills with entering velocity of 5 mm/sec. Find the final thickness of sheet if the exit velocity of rolled sheet is 25 mm/sec?
A water tank is 30 m long, 20 m wide and 12 m deep. It is made of iron sheet which is 3 m wide. The tank is open at the top. If the cost of the iron sheet is Rs. 10 per metre, then the total cost of the iron sheet required to build the tank is :
A 25 cm × 25 cm × 1 cm flat sheet weighing 1.2 kg initially was dried from both sides under constant drying rate conditions. It took 1500 seconds for the weight of the sheet to reduce to 1.05 kg. Another 1 m × 1 m × 1 cm flat sheet of the same material is to be dried from one side only. Under the same constant drying rate conditions, the time required for drying (in seconds) from its initial weight of 19.2 kg to 17.6 kg is