14 points in a row alternating up and down the mean will not indicate action needed for any process for which a control chart is plotted.

14 points in a row alternating up and down the mean will not indicate action needed for any process for which a control chart is plotted. Correct Answer False

If 14 points in a row, on a control chart, plot alternating up and down the mean, will surely indicate that that process is giving warning signals. This means the process is presently in-control but will go out-of-control in near future.
Bissoy MCQ

Related Questions

Which of the following is/are the advantages of using a control chart for inspection? (i) A control chart indicates whether the process is in control or out of control. (ii) A control chart determines process variability. (iii) A control chart ensures product quality. (iv) Scrap or percentage reduction can be reduced by taking the necessary actions in time against the warnings indicated by control charts. (v) Control charts build up the reputation of the organization through customer’s satisfaction. (vi) The control chart can detect the unusual variations taking place in a process.
The average number of points that must be plotted before an out-of-control point is plotted on an Individuals control chart?
If for a process, 18 out of 20 points are plotted above the CL but below the upper control limit, and only 2 of 20 are plotted between the center line and the lower control limit, what can we say about the process state?
চারটি সমানুপাতিক রাশির প্রান্তীয় রাশি দুটির গুনফল ২০০। প্রথম রাশিঃ দ্বিতীয় রাশি= ১ঃ২, দ্বিতীয় রাশিঃচতুর্থ রাশি= ১ঃ৪। তৃতীয় রাশিটি কত?
Statement I $$overline X $$ chart, and chart and R chart are the techniques used for product control under statistical quality control.
Statement II Operating characteristic curve helps determine whether a particular acceptance sampling plan meets both the product's and the consumer's risk requirements.
HACCP is a preventive programme for hygienic control and food safety. Arrange the following steps of the HACCP system intheir correct sequence.
1. Identifying critical control points.
2. Monitoring each critical control point.
3. Developing criteria for control and prevention.
4. Identification and assessment of hazards.
5. Taking immediate corrective action.
Suppose on performing reduced error pruning, we collapsed a node and observed an improvement in the prediction accuracy on the validation set. Which among the following statements are possible in light of the performance improvement observed? (a) The collapsed node helped overcome the effect of one or more noise affected data points in the training set (b) The validation set had one or more noise affected data points in the region corresponding to the collapsed node (c) The validation set did not have any data points along at least one of the collapsed branches (d) The validation set did have data points adversely affected by the collapsed node
In case of variables charts, for a process to be in control bothx chart and R chart should be in control.
Which of the following equation is/are not correct? Consider MWT – Mean Waiting time; ADT – Administrative delay time; LDT – Logistic delay time; MDT – Mean down time; MTTR – Mean time to repair; MTTF – Mean time to failure.
Nurse Kemp has worked more night shifts in a row than Nurse Rogers, who has worked five. Nurse Miller has worked fifteen night shifts in a row, more than Nurses Kemp and Rogers combined. Nurse Calvin has worked eight night shifts in a row, less than Nurse Kemp. How many night shifts in a row has Nurse Kemp worked?