What will be the typical process time constant for followed for discrete control in discrete manufacturing industries?

What will be the typical process time constant for followed for discrete control in discrete manufacturing industries? Correct Answer Less than a Second

The typical process time constant followed for discrete control in discrete manufacturing industries is less than a second.
Bissoy MCQ

Related Questions

Which of the following is/are the advantages of using a control chart for inspection? (i) A control chart indicates whether the process is in control or out of control. (ii) A control chart determines process variability. (iii) A control chart ensures product quality. (iv) Scrap or percentage reduction can be reduced by taking the necessary actions in time against the warnings indicated by control charts. (v) Control charts build up the reputation of the organization through customer’s satisfaction. (vi) The control chart can detect the unusual variations taking place in a process.
Which of the following is not a typical used sensor for discrete control in discrete manufacturing industries?
Which of the following is not a typically used variable for discrete control in discrete manufacturing industries?
The process of converting discrete-time continuous valued signal into discrete-time discrete valued (digital) signal is known as ____________
Statement : Drinking water supply to New Bombay has been suspended till further orders from Maharashtra Pollution Control Board following pollution of Patalganga river, caused by discharge of effluents from some chemical industries.

Courses of Action :
I. The industries responsible for discharging effluents into the river should be asked to close down immediately.
II. The river water should immediately be treated chemically before resuming supply.
III. The Pollution Control Board should check the nature of effluents being discharged into the river by industries at regular intervals.
Which industries fall under strategic area?
1. Industries related to equipments for safety and power generation.
2. Electricity, road and steel industries.
3. Industries related to railway and mineral products.
4. Health and education related industry.
Select the correct answer:
If value added manufacturing time is 65 minutes, total manufacturing time is 80 minutes, then manufacturing cycle time will be
Regulatory and feed forward are more closely associated with discrete industries rather than process industries.
If manufacturing cycle efficiency is 0.725 and total manufacturing time is 45 minute, then value added manufacturing time will be
How are production operations classified in Process and Discrete Product manufacturing industries?