The temperature rise from condenser to boiler saturation is divided __________ among the feedwater heaters for maximum gain in efficiency.

The temperature rise from condenser to boiler saturation is divided __________ among the feedwater heaters for maximum gain in efficiency. Correct Answer equally

The total enthalpy rise or the temperature rise from condenser to boiler saturation is divided equally among the feedwater heaters for maximum gain in the efficiency.
Bissoy MCQ

Related Questions

If n heaters are used, the greatest gain in efficiency occurs when overall temperature rise is ____ times the difference between condenser and boiler saturation temperatures.
In a newly developed innovative idea brought up by CSIR in India, gas turbine exhaust gas are being utilized to convert feedwater into steam. Certain data of the experiment are as follows: mass flow rate of exhaust gas = 40 kg/hr, enthalpy of exhaust gas at the time of their exit from gas turbine is 600 kJ/kg, steam turbine output as measured by brake dynamometer = 60 hp-sec, thermal efficiency of steam power plant is 0.25, efficiency of exhaust gas in converting feedwater into steam is taken as 50%. Find the enthalpy of exhaust gas remaining after they generate steam from feedwater?
The expression for temperature rise t in feedwater heater when a & b are the temperatures of boiler saturation & condenser respectively, is given by which of the following expression?
A regenerative feedwater heating cycle with an infinite number of feedwater heaters has efficiency equal to?
Read the following statements about feed water heaters I. Open or contact heaters are also called Deaerator. II. Open or contact heaters constructed to remove non-condensable gases from feed water.
What is the expression for enthalpy of each heater hper heater if a represents the enthalpy of heated feedwater from the economiser and b represents the enthalpy at condenser & n represents the number of heaters?
A two pass surface condenser is required to handle the exhaust from a turbine developing 15 MW with specific steam consumption of 5 kg/k W h. The quality of exhaust steam is 0.9, the condenser vacuum is 66 cm of mercury while the bar meter reads 76 cm of mercury. The condenser tubes are 28 mm inside diameter, 4 mm thick and water flows through tubes with a speed of 3 m/s and inlet temperature 20 degree Celsius. All the steam is condensed, the condensate is saturated water and temperature of cooling water at exit is 5 degree Celsius less than the condensate temperature. Assuming that overall coefficient of heat transfer is 4 k W/m2 degree, determine the mass of cooling water circulated
In a steam turbine power plant, the boiler feedwater temperature is marked as 30 deg C, ocean as sink with temperature 20 deg C and desired thermal efficiency of the plant is 0.46. Find the temperature of steam entering the turbine?
A cam should be designed only using uniform rise and fall within half of the cam, the remaining is dwell period, and without any dwell period in between the rise -fall periods and rise and fall periods should be same. The maximum rise in follower is 30 mm. How much the follower will rise when the follower is 120 degrees from its initial position of a cam?
A cam should be designed only using uniform rise and fall within half of the cam, the remaining is dwell period, and without any dwell period in between the rise-fall periods and rise and fall periods should be same. The maximum rise in follower is 45 mm. How much the follower will rise when the follower is 45 degrees from its initial position of a cam?