Which of the following option is correct about bench micrometer? Statement 1: Friction free motion transfer between anvil and indicator. Statement 2: Anvil is retractable by trigger control.

Which of the following option is correct about bench micrometer? Statement 1: Friction free motion transfer between anvil and indicator. Statement 2: Anvil is retractable by trigger control. Correct Answer Both the statements are correct

There is a mechanism for linear friction free motion transfer between anvil and indicator. This is to achieve high accuracy. Retracting of the anvil is done by trigger control. Work is placed between spindle and anvil after retracting and then released.
Bissoy MCQ

Related Questions

Which of the following option is correct about given statements about micrometer? Statement 1: The anvil should not protrude from the frame. Statement 2: An adjusting nut is present in micrometer to compensate wear
Which of the following option is true for the given statements about micrometer? Statement 1: There is a fixed spindle and a rotated anvil. Statement 2: For taking the reading, micrometer dimension is set slightly larger than part size.
The CREATE TRIGGER statement is used to create the trigger. THE _____ clause specifies the table name on which the trigger is to be attached. The ______ specifies that this is an AFTER INSERT trigger.
Which of the following is/are the advantages of using a control chart for inspection? (i) A control chart indicates whether the process is in control or out of control. (ii) A control chart determines process variability. (iii) A control chart ensures product quality. (iv) Scrap or percentage reduction can be reduced by taking the necessary actions in time against the warnings indicated by control charts. (v) Control charts build up the reputation of the organization through customer’s satisfaction. (vi) The control chart can detect the unusual variations taking place in a process.
Up to which comparator measurements, dial indicator of bench micrometer can be used?
Which of the following option is correct for given statements about dial comparator bench micrometer? Statement 1: Moving parts are of satin chrome finish. Statement 2: Extra large thimble is present.
To check the bending in micrometer, what is the difference between the measurement of loaded and unloaded conditions for micrometer range 0 to 25 mm?
Match the following Types of mechanism Motion achieved P. Scott Russel mechanism 1. Intermittent motion Q. Geneva mechanism 2. Quick return motion R. Off set slider crank mechanism 3. Simple harmonic motion S. scotch Yoke mechanism 4. Straight line motion
What is the value of total error for grade 1 micrometer when micrometer is tested at 20oC?
Which of the following is correct about dial comparator bench micrometer?