Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

Speed reduction in a gear box is achieved using a worm and worm wheel. The worm wheel has 30 teeth and a pitch diameter of 210 mm. If the pressure angle of the worm is 20o, what is the axial pitch of the worm?
A gear train consist of spur gear as shown. Gear A receives 4kW of power at 750rpm through its shaft and rotates in CW direction. A gear train consist of spur gear as shown. Gear A receives 4kW of power at 750rpm through its shaft and rotates in CW direction. Calculate the torque on the gear C if number of teeth on gear A, B and C are 40, 70 and 30.
A planetary gear train is shown in the figure. Number of teeth on the sun gear A, planet gear B and fixed ring gear D are given by 30, 70 and 140 respectively. Module is taken as 5mm. Calculate the shaft angle for opposite hand of helix if helix angle of two gears are 20⁰ and 17⁰.
A worm gear set is designed to have pressure angle of 300 which is equal to the helix angle. The efficiency of the worm gear set at an interface friction of 0.05 is
The base diameter of a conical helix is 100 mm. The angle between the base and slanting side is 45 degrees. Pitch of helix is 5 mm. What is the height of helix and number of revolutions?
The base diameter of a conical helix is 80 mm. The angle between the base and slanting side is 60 degrees. Pitch of helix is 6 mm. What is the height of helix and number of revolutions?
A planetary gear train is shown in the figure. Number of teeth on the sun gear A, planet gear B and fixed ring gear D are given by 30, 70 and 140 respectively. Module is taken as 5mm. A pair of spur gears consist of 25 teeth pinion meshing with a 115 teeth gear. The module is 5mm. Calculate the gear ratio.
Base diameter of conical helix is 50 mm, height of helix is 30 mm, angle between the base and slanting side of cone is 60 degrees. What is the top end diameter of the helix?
A pair of parallel helical gears consist of 15 teeth pinion meshing with a 40 teeth gear. The helix angle is 22⁰ and normal pressure angle 19⁰. The normal module is taken as 4mm. Calculate the pitch circle diameter of the gear.
Following is the data for transmission system of a Gear box reduction ratios.
1st gear - 4.3 : 1
2nd gear - 3.00 : 1
3rd gear - 2.71 : 1
4th gear - 1 : 1
Final drive reduction is 5.0 : 1
The overall reduction when the vehicle is driven in 2nd gear is