_____________ is the friction, experienced between the rubbing surfaces, when the surfaces have a thick layer of the lubricant.

_____________ is the friction, experienced between the rubbing surfaces, when the surfaces have a thick layer of the lubricant. Correct Answer Fluid friction

Fluid friction is the friction, experienced between the rubbing surfaces, when the surfaces have a thick layer of the lubricant. In this case, the actual surfaces do not come in contact and thus do not rub against each other.
Bissoy MCQ

Related Questions

______________ is the friction, experienced between the rubbing surfaces, when the surfaces have a very thin layer of lubricant.
A composite slab consists of 5 cm thick layer of steel (k = 146 kJ/m hr degree) on the left side and a 6 cm thick layer of brass (k = 276 kJ/m hr degree) on the right hand side. The outer surfaces of the steel and brass are maintained at 100 degree Celsius and 50 degree Celsius. The contact between the two slabs is perfect and heat is generated at the rate of 4.2 * 10 5 k J/m2 hr at the plane of contact. The heat thus generated is dissipated from both sides of composite slab for steady state conditions. Calculate the temperature at the interface
When the rubbing surfaces are separated from each other by a very thin film of lubricant it is known as
A multiple disc clutch has five plates having four pairs of active friction surfaces. If the intensity of pressure is not to exceed 0.127 N/mm2, find the power transmitted at 500 r.p.m. The outer and inner radii of friction surfaces are 125 mm and 75 mm respectively. Assume uniform wear and take coefficient of friction = 0.3.
To effect a bond between two metal plates, 2.5 cm and 15 cm thick, heat is uniformly applied through the thinner plate by a radiant heat source. The bonding must be held at 320 K for a short time. When the heat source is adjusted to have a steady value of 43.5 k W/m2, a thermocouple installed on the side of the thinner plate next to source indicates a temperature of 345 K. Calculate the temperature gradient for heat conduction through thinner plate. In the diagram, the upper plate is 2.5 cm thick while the lower is 15 cm thick.
When the lubrication is arranged so that rubbing surfaces are separated by a fluid film, and the load on the surfaces is carried entirely by the hydrostatic or hydrodynamic pressure in the film, it is known as
Which of the following statements are true in case of fluid-mosaic model for cell membrances
P. Between 5 - 8 nm thick and appear trilaminar when viewed in cross-section under electron microscope
Q. Less than 1 nm thick and consist of a layer of protein sandwitched between two layers of phospholipids
R. In the lipid bilayer, proteins are embedded at irregular intervals and held by hydrophilic interactions between lipids and hydrophilic domains of the proteins
S. The protein domains exposed on one side of the lipid bilayer are different from those exposed on the other side
In the following passage, some of the words have been left out. Read the passage carefully and select the correct answer for the given blank out of thefour alternatives.
One who has witnessed a debate ______ argument between two men _____________ strong intellectually, one of whom is a trained logician and the other lacking this advantage, will never forget the impression produced _________ him by the unequal struggle. The conflict is like that of a ____________ wrestler, untrained in the little tricks and turns of the science, in the various principles of applying force in a certain way at a certain time, at a certain place, with a __________ and experienced wrestler.
certain place, with a __________ and experienced wrestler
_____________ friction is the force of friction experienced by a body when it is at rest.
The hydrodynamic friction is associated with the phenomena when a complete film of lubricant exists between the two bearing surfaces.