Related Questions

Bifilar suspension method is used to find the
A angular acceleration of the body
B moment of inertia of the body
C periodic time of the body
D frequency of vibration of the body
Some wire- wound resistors have bifilar winding. This type of winding is used to
A Increase the thermal stability
B Reduce the tolerance
C Reduce the inductance of winding
D Double the power rating of the resistor
To ensure that the hogging bending moment at two points of suspension of a pile of length L equals the sagging moment at its centre, the distances of the points of suspension from either end, is
A 0.107 L
B 0.207 L
C 0.307 L
D 0.407 L
__________ is used for producing a thick suspension from a thin slurry.
A Cartridge filter
B Rotary drum vacuum filter
C Pressure filter thickener
D Plate and frame filter press
Which articles of the Constitution of Bangladesh remain under suspension during the period of emergency?
A 36, 37, 38, 40, 41, 42
B 36, 37, 38, 39, 40, 41
C 36, 37, 38, 39, 40, 42
D 36, 37, 38, 39, 41, 42
The basic function of the suspension is to
A Absorbs vibration and impact forces from the road surface
B Ensure that the steering wheel can deliver a suitable amount of steering force
C Ensure that wheel alignment is not disturbed during driving
D Automatically correct the effects of over steering
If a suspended body is struck at the centre of percussion, then the pressure on die axis passing through the point of suspension will be
A Maximum
B Minimum
C Zero
D Infinity
Base suspension fertiliser essentially contains
A 13% N2 and 43% P2O5
B 43% N2 and 13% P2O5
C 43% N2 and 13% K2O
D 43% K2O and 43% P2O5
The main feature of MacPherson strut suspension is that
A The vertical size of the suspension can be made more compact
B The unsprung mass in lighter
C The assembly is slightly more complicated in design
D Non-vertical external forces are supported by the suspension arms
The rigid suspension is beneficial when
A It is desired to reduce the unsprung mass
B It is desired to improve tyre-to-ground contact characteristics
C large changes in load make it necessary to have a large suspension stroke
D It is desired to have more flexibility in design

Next steps