The velocity and the electrolyte flow through the gap is also an important parameter affecting the surface finish and MRR.

The velocity and the electrolyte flow through the gap is also an important parameter affecting the surface finish and MRR. Correct Answer True

If the velocity is too low, the heat and by-products of the reaction build in the gap causing non-uniform material removal. A velocity that is too high will cause cavitation, also uneven material removal.
Bissoy MCQ

Related Questions

In the following question, two statements are numbered as Statement I and II. On solving these statements we get Quantity A and B respectively. Solve the given statements for both quantities and choose the correct option. Statement I: 5 men can finish work in 25 days. After 12 days, 2 workers have fallen sick. How much approximate time does it take to finish the work by remaining workers? Statement II: 12 men can finish a work in 28 days and 10 women can finish the same work in 30 days. What is the approximate time taken by 7 men and 5 women to finish this work?
A can finish a work in half the time taken by B to finish the work. The time taken by C to finish the work is equal to the total time taken by A and B together to finish the work. What is the ratio of the time taken to finish the work when A, B and C work together to that of the time taken by A working alone?
X women can finish a work in 2Y days. 1.5X men can finish that same work in Y days and 3X children can finish the same work in 2Y days. 8 Men, 8 Women and 8 children can finish a work in 45/2 days. 9 men can finish the same in Y + 20 days. What is the value of X, Y?
A gap opening penalty for any gap (g) and a gap extension penalty for each element in the gap (r) are most often used, to give a total gap score wx, according to the equation ______
In case of an automobile battery, following are the reasons which will cause a defect of
1. Very high charging rate
2. High specific gravity of electrolyte
3. Freezing of electrolyte
4. Improper level of electrolyte
5. Mechanical damage due to rough handling or not fixed in the vehicle
Which of the following statements are correct? 1) Velocity compounded impulse turbine gives less speed and less efficiency. 2) For an ideal centrifugal compressor, the pressure produced depends on impeller velocity and diameter. 3) While flowing through the rotor blades in a gas turbine, the relative velocity of gas continuously decreases. 4) While flowing through the rotor blades in an axial flow compressor, the relative velocity of air continuously decreases.
The depth ‘d’ below the free surface at which the point velocity is equal to the average velocity of flow for a uniform laminar flow with a free surface, will be (where D is the depth of flow)
A and B can finish a work in 9 days, B and C can finish it in 12 days and A and C can finish it in 18 days. In how many days can A, B and C finish the work together?
A and B together can finish a job in 6 days, B and C together can finish the job in 8 days and C and A together can finish it in 24 days. How much time will A, B and C together take to finish the job?
A and B together can finish a work in 10 days, B and C together can finish the same work in 15 days, and A and C together can finish the same work in 20 days. In how many days can c alone finish the same work?