The distribution of concrete in the strain compatibility method is?

The distribution of concrete in the strain compatibility method is? Correct Answer Linear

The distribution of concrete strain is linear (plane section normal to axis remains plane even after bending), the basic theory is applicable to all structural concrete sections whether reinforced or prestressed and some assumptions are made.
Bissoy MCQ

Related Questions

From an alloy, two specimens are machined and tested separately under tension and compression. The engineering stress-strain curves as well as the true stress-true strain curves for tension and compression are plotted in the same diagram. Identify the correct statements:
P. The engineering stress-strain curves in tension and compression are identical.
Q. The true stress-true strain curve in compression is lower than the true stresstrue strain curve in tension due to Bauschinger effect.
R. The true stress-true strain curve in tension is above the corresponding engineering stress-strain, curve.
S. The true stress-true strain curve in tension and compression are identical.
The true strain rate is given as ϒ, and conventional strain rate is given as ε. The engineering strain is equal to e. The relationship between conventional strain rate and true strain rate is _______
The estimation based on compatibility of the strain of prestressed concrete involves __________
The relationship between the true strain and engineering strain is given as _____ Where e=conventional strain, ε= Engineering strain
The number of steps to be followed in the strain compatibility method is?
The strain compatibility method is generally applicable for __________
The strain compatibility method of analysis involves the use of ____________
A concrete beam of rectangular section 100mm wide, area is 3×104, initial stress is 1200n/mm2 of 7mm diameter located at an eccentricity 50mm. Estimate the loss of stress due to creep of concrete using the ultimate creep strain method?
Every direct stress is always accompanied by a strain in its own direction and an opposite kind of strain in every direction, at right angles to it. Such a strain is known as
A cylinderical rod subjected to a tensile strain within the elastic limit undergoes a volume change. If the volume strain is equal to half the tensile strain, then the Poisson's ratio of the rod is