The compression in concrete and tension in steel are developed by?

The compression in concrete and tension in steel are developed by? Correct Answer Expansion cements

Compression in concrete and tension in steel is developed by use of expanding cements due to its elastic property or expanding property, joint cement is an adhesive used primarily for attaching the joint tape that is placed over the beams whereas water cement ratio is the ratio of the weight of water to weight of cement used in a concrete mix.
Bissoy MCQ

Related Questions

From an alloy, two specimens are machined and tested separately under tension and compression. The engineering stress-strain curves as well as the true stress-true strain curves for tension and compression are plotted in the same diagram. Identify the correct statements:
P. The engineering stress-strain curves in tension and compression are identical.
Q. The true stress-true strain curve in compression is lower than the true stresstrue strain curve in tension due to Bauschinger effect.
R. The true stress-true strain curve in tension is above the corresponding engineering stress-strain, curve.
S. The true stress-true strain curve in tension and compression are identical.
An ___________________ beam is one in which the tension capacity of the tensile reinforcement is smaller than the combined compression capacity of the concrete and the compression steel (under-reinforced at tensile face).
Determine the correctness or otherwise of the following Assertion (a) and Reason (r).
Assertion: During rolling, front tension and (or) back tension are (is) employed to decrease rolling load.
Reason: Roll pressure decreases due to lowering of flow stress as a result of front tension/back tension.
If a material with high strength in tension, such as steel, is placed in concrete, then the composite material, reinforced concrete, resists not only compression but also bending and other direct tensile actions.
In which beam tension capacity of steel is greater than combined compression capacity of steel and concrete?
In vapor compression cycle having dry saturated vapor at the end of compression the work done is given by? H2 – Enthalpy of vapor after compression H1 – Enthalpy of vapor before compression
In vapor compression cycle having dry saturated vapor at the end of compression the refrigeration effect is given by? H1 – Enthalpy of vapor before compression H4 – Enthalpy of vapor before entering evaporator H2 – Enthalpy of vapor after compression
Which of the following is not a method for providing effective lateral restraints? (i) by embedding compression flange inside slab concrete (ii) by providing shear connectors in compression flange (iii) by bracing compression flanges of adjacent beams
The section of a reinforced beam where most distant concrete fibre in compression and tension in steel attains permissible stresses simultaneously, is called
The utilization of concrete in tension zone of prestressed concrete member saves concrete ranging between ___________