Related Questions

The common keyboard arrangement is called the ----layout.
A QEWTYR
B QYWERT
C QYTRWE
D QWERTY
In slide layout panel how many layouts are available for text layout by default?
A 4
B 7
C 12
D None of above
Rahim wants to cut a rectangular board into indentical square piece. If the board is 18 inched by 30 inches what is the least number of square pieces he can cut without wising any of the board?
A 4
B 6
C 9
D 15
Two boards are being cut for a construction project. If the total length of the boards is 100 inches and the shorter board is 5 inches less than half the length of the longer board , what is the length of the shorter board?
A 25 inches
B 30 inches
C 35 inches
D 70 inches
Two boards are being cut for a construction project . If the total length of the boards is 100 inches and the shorter board is 5 inches less than half the length of the longer board, what is the length of the shorter board ?
A 65 inches
B 75 inches
C 70 inches
D 80 inches
Two boards are being cut for a construction project. If the total length of the boards is 100 inches and the shorter board is 5 inches less than half the length of the longer board, what is the length of the shorter board?
A 65 inches
B 75 inches
C 70 niches
D 80 inches
How many keys are available in the Numerical Key Pad of a standard Key-board ?
A 20
B 15
C 17
D 13
Which of the following is not the value the key property will hold if the key is a function key?
A F8
B F2
C F9
D Left
When assigning a shortcut key to a symbol, you should always try to select a key or key combination that is:
A Unassigned
B Located on the ten-key pad section of your keyboard.
C Assigned to another task.
D From the same font family as the symbol.
A taper key which fits half in the key way of the hub and half in the key way of shaft, is known as
A sunk key
B flat saddle key
C hollow saddle key
D tangent key

Next steps