A FACTS Controller never has high power ac switches in its assembly.

A FACTS Controller never has high power ac switches in its assembly. Correct Answer False

“A FACTS Controller never has high power ac switches in its assembly” – is a false statement. Structurally, FACTS Controllers constitute an assembly with required combination of ac-to-dc converters, dc-to-ac converters and even high power ac switches. FACTS applications exhibit a three-phase power rating ranging from tens to hundreds of megawatts.
Bissoy MCQ

Related Questions

To configure the VLAN trunking protocol to communicate VLAN information between two switches, what two requirements must be met?
1. Each end of the trunk link must be set to the IEEE 802.1e encapsulation.
2. The VTP management domain name of both switches must be set the same.
3. All ports on both the switches must be set as access ports.
4. One of the two switches must be configured as a VTP server.
5. A rollover cable is required to connect the two switches together.
6. A router must be used to forward VTP traffic between VLANs.
A 3 - ϕ CSI used for the speed control of an induction motor is to be realized using MOSFET switches as shown below. Switches S1 to S6 are identical switches. The proper configuration for realizing switches S1 to S6 is
Consider the following statements: 1. Integral controller improves steady state response 2. By use of proportional controller, maximum peak overshoot decreases 3. Type and order of system reduces by one for derivative controller 4. Integral controller makes the system less stable in transient state due to oscillations Select the correct answer using the codes given below:
Given below are certain facts about the Constituent Assembly. Choose the options which give the correct information about the same. A. The number of members of the Constituent Assembly was reduced to 289 after the partition of India. B. Rajendra Prasad was the second permanent President of the Constituent Assembly. C. In 1946, Alladi Krishnaswamy Iyer was appointed as the assembly's constitutional adviser. D. Constitution was adopted on 24 January 1950 by the Constituent Assembly.
Consider the following statement regarding changes made by the Indian Independence Act of 1947 in the position of Constituent Assembly. a. The Constituent Assembly was made a fully sovereign body. b. The Constituent Assembly became the first Parliament of free India. c. When the Constituent Assembly met as the Legislative body it was chaired by Dr. Rajendr Prasad. d. The total strength of the Constituent Assembly came down to 299 as against 389.
You create an assembly by using Visual Studio .NET. The assembly is responsible for writing and reading order entry information to and from an XML data file. The assembly also writes and reads values to and from the Windows registry while it is being consumed. The assembly will be distributed to client computers by using your company, XYZ, intranet. All client computers are configured to implement the default .NET security policy. You need to implement security in the assembly. What should you do?
In FACTS technology, the controller employed in the transmission system is always a single high-power Controller.
On a non-pipelined sequential processor, a program segment, which is a part of the interrupt service routine, is given to transfer 500 bytes from an I/O device to memory.     Initialize the address register     Initialize the count to 500 LOOP: Load a byte from device     Store in memory at address given by address register     Increment the address register     Decrement the count     If count! = 0 go to LOOP Assume that each statement in this program is equivalent to a machine instruction which takes one clock cycle to execute if it is a non-load/store instruction. The load-store instructions take two clock cycles to execute. The designer of the system also has an alternate approach of using the DMA controller to implement the same transfer. The DMA controller requires 20 clock cycles for initialization and other overheads. Each DMA transfer cycle takes two clock cycles to transfer one byte of data from the device to the memory. What is the approximate speedup when the DMA controller based design is used in place of the interrupt driven program based input-output?
In the question two statements are given, followed by two conclusions, I and II. You have to consider the statements to be true even if it seems to be at variance from commonly known facts. You have to decide which of the given conclusions, if any, follows from the given statements. Statement I: Some buttons are switches Statement II: All buttons are connectors Conclusion I: Some switches are connectors Conclusion II: Some connectors are buttons
List I embodies situational leadership style and List II indicates the power resource which supports them. List I Situational leadership style List II Power resource a)  Directive style (HT / LR) i) Expert power b) Supportive style (HT / HR) ii)  Information power c) Participative style (LT / HR) iii)  Reward power d)  Delegating style (LT / LR) iv)  Coercive power   *HT = High Task LT = Low Task HR = High Relationship LR = Low Relationship Choose the correct answer from the options given below: