In electrical system, FACTS is a power-electronics based system.

In electrical system, FACTS is a power-electronics based system. Correct Answer True

It is true that in electrical system, FACTS is a power-electronics based system. The underlying reason behind this statement is that unlike large rotating machines being used as synchronous condensers or switched capacitor banks to compensate for reactive power; FACTS employs static equipment, AR compensators controlled by power electronic devices like thyristors for making up or taking away reactive power. This results in smooth control of reactive power and ultimate maintenance of a good voltage profile in the power system.
Bissoy MCQ

Related Questions

Match the following Device Conversion of Energy (a) Windmill (i) Chemical Energy to electrical energy (b) Bulb (ii) Kinetic Energy to Electrical Energy (c) Electrical Cell (iii) Sound Energy to Electrical energy (d) Microphone (iv) Electrical Energy to Light Energy
What does hydropower change A. Kinetic energy to electrical energy B. Mechanical energy from electrical energy C. Chemical energy to electrical energy D. Wind energy to electrical energy
Some pairs of devices and associated energy changes are given below: i) Electric generator - Mechanical to electrical ii) Electric motor - Electrical to mechanical iii) Diesel engine - Light to electrical iv) Solar cell - Chemical to mechanical Which of the above pair / s is/are correctly matched?
Which type of fire extinguishers are used to put out electrical fires from electrical components or energized electrical equipment?
Consider the following regarding the transformation of energy.  I. Dynamo: Electrical energy into mechanical energy  II. Sitar: Electrical energy into sound energy  III. Tube light: Electrical Energy into light energy  Which among the above is/are correct?
In the following question, sentences of a paragraph have been jumbled and labelled as A, B, C and D. You are required to rearrange the jumbled sentences of the paragraph and mark your response accordingly by selecting the correct option. A: Transformers can also be used for isolation, where the voltage in equals the voltage out, with separate coils not electrically bonded to one another. B: Transformers are most commonly used for increasing low AC voltages at high current (a step-up transformer) or decreasing high AC voltages at low current (a step-down transformer) in electric power applications. C: It was discovered in 1831. D: A transformer is a passive electrical device that transfers electrical energy from one electrical circuit to another.
Some pairs of devices and associated energy changes are given below.
1. Electric generator ⟺ Mechanical to electrical
2. Electric motor ⟺ Electrical to mechanical
3. Diesel engine ⟺ Light to electrical
4. Solar cell ⟺ Chemical to mechanical
Which of the above pair/s is/are correctly matched?
Principle: A person who voluntarily takes a decision to do something after appreciating the risk involved in such act and then receives an injury, will not be entitled to get any compensation.
Facts: 'X', an electrical engineer, was invited by his friend 'Y', to the factory where he was employed. While they were in the factory, 'Q' a worker in the factory informed 'Y' about some short-circuit in the power room. Hearing this, 'Y' asked 'X' to stay in the office room and rushed to the power room. 'X' however, decided to follow 'Y'. 'X' noticed that if the power supply through a particular electric line could be disconnected, the electrical leakage could be stopped which would prevent further damage. Suddenly 'X' decided to pullout the wire manually even though it was risky. This resulted in a blast in which both 'X' and 'Y' got injured. 'X' had to spend Rs. 1 lakh at the hospital for his treatment. 'X' wants to file a suit for compensation from the management of the factory. Will he succeed?
Consider the following statements: 1. Dynamic cone penetration test for site investigation is based on the principle that elastic shock waves travel in different materials at different velocities. 2. Electrical resistivity method of subsurface investigation is capable of detecting only the strata having different electrical resistivity. 3. In-situ vane shear test is useful for determining the shear strength of very soft soil and sensitive clays and is unsuitable for sandy soil. Which of these statements is/are correct?
1. A student drew a neat and error-free graph on a graph paper basing on the given data relating to physics. 2. The student answered the questions based on the graph correctly. 3. The student predicted the trend of the graph correctly by studying its nature. Out of the knowledge, understanding, application and skill based educational objectives, the above mentioned facts are based altogether on how many objectives?