Bissoy.com
Doctors Medicines MCQs Q&A

The three transmission line operating parameters used to determine the transmitted power are voltage, impedance and angle.

The three transmission line operating parameters used to determine the transmitted power are voltage, impedance and angle. Correct Answer True

The three transmission line operating parameters used to determine the transmitted power are voltage, impedance and angle. FACTS controllers accordingly act on one or more of these parameters to achieve targeted transmission system compensation and mitigate control problems. The most noteworthy dissimilarity between the approaches availed by the FACTS controllers lies in the capability to generate reactive power and exchange real power.

Related Questions

For a lossy transmission line, γ=0.02+j0.15 and is 20m long. The line is terminated with an impedance of a 400Ω. Then the input impedance of the transmission line given that the characteristic impedance of the transmission line is 156.13+j11.38Ω is:
The characteristic impedance of the transmission line if the outer diameter and inner diameter of the transmission line is 20 mm and 10 mm respectively, given the intrinsic impedance of the medium is 377 Ω, then the characteristic impedance of the transmission line is:
If the transmission co-efficient T₁ of a transmission line is 1.333 and the characteristic impedance of the λ/4 transmission line used is 100Ω, then the characteristic impedance of the transmission line is:
After conjugate impedance matching the input impedance used for matching after normalization was 1+j with the characteristic impedance of the transmission line being 100Ω, then the generator impedance must have been:
When a transmission line of characteristic impedance(50Ω) zₒ is matched to a load by a λ/4 transmission line of characteristic impedance 100Ω, then the transmission co efficient is:
Which of the following has to be considered for overhead/underground electrical power transmission / distribution system? a) The voltage at the consumer’s premises must be maintained within ± 4 or ± 6% of the declared voltage. b) The transmission cost should be unduly excessive. c) The insulation resistance of the whole system should be very high d) The loss of power in the system itself should be a small percentage (about 10%) of the power transmitted.
For the figure depicting the two generators connected via the transmission line having and impedance ‘jX’ ohms. Machine A at voltage Va at angle δ will supply active power to machine B at voltage Vb and angle zero, when δ is _____________
If the input impedance of a ƛ/2 transmission line is 100 Ω with a voltage reflection coefficient of 0.344, then the characteristic impedance of the transmission line is:
If a λ/4 transmission line is 100Ω is used to match a transmission line to a load of 100Ω, then the characteristic impedance of the transmission line is:
Transmitted real power through transmission power system is a function of the transmission line impedance.