In a transformer the tappings are generally provided on

A Primary side
B Secondary side
C Low voltage side
D Can be connected to any side

Correct Answer: Can be connected to any side

The turns ratio is different with different tappings and hence different voltages are obtained with different tappings adjustment. The tappings are placed either on high voltage or low voltages or sometimes on both high and low voltage windings to get required output.
Bissoy MCQ
#Transformers #Real Transformer and Equivalent Circuit

Related Questions

In a tap changing transformer, the tappings are provided on
A Primary winding
B Secondary winding
C High voltage winding
D Any of the above
Power amplifiers generally use transformer coupling because transformer per-mits
A Cooling of the circuit
B Impedance matching
C Distortionless output
D Good frequency response
Which of the following is the main advantage of an auto-transformer over a two-winding transformer?
A Eddy losses are totally eliminated
B Copper losses are negligible
C Saving in winding material
D Hysteresis losses are reduced
The output transformer used in a power amplifier is a ___________ transformer
A 1:1 ratio
B Step-up
C Step-down
D None of the above
The changes in volume of transformer cooling oil due to variation of atmospheric tem-perature during day and night is taken care of by which part of transformer
A Conservator
B Breather
C Bushings
D Buchholz relay
Which of the following is the main advantage of an auto-transformer over a two winding transformer?
A Hysteresis losses are reduced
B Saving in winding material
C Copper losses are negligible
D Eddy losses are totally eliminated
Transformer coupling is generally employed when load resistance is
A Large
B Very large
C Small
D None of the above
Pure oxide refractories are generally monocrystaliine in nature and are self bonded __________ bricks are generally used as moderator in nuclear reactors.
A Beryllia
B Carborundum
C Corundum
D Thoria
Generally grounding is provided for
A only for the safety of the equipment
B only for the safety of the operating personnel
C both (A) and (B)
D none of the above
The slope on the road surface generally provided on the curves is known as
A Angle of friction
B Angle of repose
C Angle of banking
D None of these

Next steps