What are the phase voltages when T1, T2 and T3 are conducting? Consider a star connected R load.

What are the phase voltages when T1, T2 and T3 are conducting? Consider a star connected R load. Correct Answer VYN = VRN = Vs/3, VBN = – 2Vs/3

When 6, 1 and 2 are conducting and the others are off. They conducting SCRs can be represented as closed switches. The load terminals R and Y are connected to the positive bus and the terminal B is connected to the nrgative bus. Supply voltage is Vs. VRN = VYN = Vs/3. VBN = -2Vs/3. It should be noted that at any time, the summation of these phase voltages must be zero.
Bissoy MCQ

Related Questions

What are the phase voltages when T6, T1 and T2 are conducting? Consider a star connected R load.
What is the R phase voltage and Y phase voltage when only T3 and T4 are conducting? Consider a star connected balanced R load.
A 4-pole, 3-phase slip ring induction motor is used as a frequency changer. Its stator is excited from 3-phase, 50 Hz supply. A load requiring 3-phase, 20 Hz supply is connected to the star-connected rotor through three slip-rings of SRIM. At what two speeds the prime mover should drive the rotor of this SRIM?
A step-down delta-star transformer, with per-phase turns ratio of 5 is fed from a 3-phase 1100 V source. The secondary of this transformer is connected through a 3-pulse type rectifier, which is feeding an R load. The power delivered to the load is 6839.3 Watts. The maximum value of the load current is √2 x 22 A. Fin, the rms value of output voltage Vo (rms)
What is the R phase voltage when T1, T6 and T5 are conducting? Consider a star connected R load.
What is the R phase voltage when only T1 and T2 are conducting from 60° to 120°. Consider star connected R load.
What is the B phase voltage when only T1 and T2 are conducting from 60° to 120°. Consider star connected R load.
At a 33kV 50 Hz to a bus a load of 35 MW is connected. To improve the power factor to unity a synchronous phase modifier is connected taking 5 MW. If the SPM is represented as delta connected impedance, where in each phase we have capacitor connected parallel to resistance forming RC parallel network, then the value of this resistance is ___________
At a 33kV 50 Hz to a bus a load of 35 MW is connected. To improve the power factor to unity a synchronous phase modifier is connected taking 5 MW. If the SPM is represented as delta connected impedance, where in each phase we have capacitor connected parallel to resistance forming RC parallel network, then the value of this capacitance is __________
In a certain three-wire Y-connected generator, the phase voltages are 2 kV. The magnitudes of the line voltages are