Related Questions

Consider the following statements: 1. The voltage developed across the OFF switches of the half-bridge converter is the maximum dc-link voltage. 2. In the full-bridge converter, the voltage across the primary of the transformer is the dc link voltage. 3. The voltage developed across the OFF switches of the full-bridge converter is half the maximum dc-link voltage. Which of the above statements are correct?
A 3-phase full converter has an average output voltage of 365 V for zero degree firing and resistive load. For a firing angle of 90 degree, the output voltage would be
For the following RC triggering circuit with R load and a firing angle of α, the voltage across the R load is zero for
Which of the following statements are correct for an ideal constant voltage source? 1. Its output voltage remains absolutely constant whatever the change in load current. 2. It possesses zero internal resistance so that internal voltage drop in the source is zero. 3. Output voltage is provided by the source would remain constant irrespective of the amount of current drawn from it. 4. Output voltage provided by the source varies with the amount of current drawn from it.
Which one of the following statements is/are incorrect regarding waves? (A) wave height is not indicator of wave energy (B) wave height is controlled by wind strength (C) the distance of open water a wave travels over affects the wave height (D) the depth of the sea is important factors affecting wave height Choose the most appropriate answer from the options given below:
In a single-phase full-wave bridge circuit and in a three-phase, delta full-wave bridge circuit, what will be the ripple voltage frequency respectively?
For the following RC triggering circuit with R load and a firing angle of α, the voltage across the SCR (thy2) will be zero for
What are the steps required in sequence to solve a circuit using superposition theorem? (a) Select any one source and short circuit all other voltage sources. (b) Find out the current or voltage across the required element, due to the source under consideration. (c) Open all current sources, if the internal impedance is not known. If known replace them by their impedances. (d) Add all the individual effects produced by individual sources to obtain the total current in or across the voltage element. Code :
For the below given circuit, after the switch is closed the voltage across the load (shown open) remains constant. Assuming that all initial conditions are zero. The element across the load would be a/an
A single-phase half-wave rectifier with a FD is supplied by Vs = 240 V, 50 Hz, AC source with a load R = 10 Ω, L = 0.8 mH. The firing angle is so adjusted such that the output voltage obtained is 100 V. Find the firing angle.