Related Questions

The bypass factor, in case of sensible cooling of air, is given by (where td1 = Dry bulb temperature of air entering the cooling coil, td2 = Dry bulb temperature of air leaving the cooling coil and td3 = Dry bulb temperature of the cooling coil)
Consider a given volume of liquid at a temperature T below Tm with a free energy G’. If some of the atoms of the liquid cluster together to form a small sphere of solid, the free energy of the system will change to G, given by________ (Assume V1 volume of the solid sphere, V2 volume of liquid, A is the solid/liquid interfacial area, γ solid/liquid interface free energy, G1 and G2 are the free energies per unit volume of solid and liquid respectively).
The dependences of the magnetic susceptibility $$\left( \chi \right)$$ of a material with temperature (T) can be represented by $$\chi \propto \frac{1}{{T - \theta }},$$   where θ is the Curie-Weiss temperature. The plot of magnetic susceptibility versus temperature is sketched in the figure, as curves P, Q and R with curve Q having θ = 0. Which one of the following statements is correct?
Solid State Physics mcq question image
In an amorphous material, atoms defy any definite atomic structure and exist in random pattern just like in liquid. Which of the following is an amorphous material?
Concentrated fermentation liquid containing 20% (w/w) gluconic acid from an evaporator has a flow rate of 2000 kg/h and a temperature 90 °C. It needs to be cooled to 6 °C in a heat exchanger with cooling water. The cooling water has a flow rate 2700 kg/h and an initial temperature 2 °C. If the cooling water leaves the heat exchanger at 50 °C, what is the rate of heat loss from gluconic acid solution to the surroundings? Assume the heat capacity of gluconic acid is 0.35 cal/g-°C-1.
While the thermosetting polymers are amorphous in nature, the thermoplastic polymers are either amorphous or crystalline. The crystalline polymers are characterised by the
The ratio of the temperature rise of cooling water to the vacuum temperature minus inlet cooling water temperature is called
A two pass surface condenser is required to handle the exhaust from a turbine developing 15 MW with specific steam consumption of 5 kg/k W h. The quality of exhaust steam is 0.9, the condenser vacuum is 66 cm of mercury while the bar meter reads 76 cm of mercury. The condenser tubes are 28 mm inside diameter, 4 mm thick and water flows through tubes with a speed of 3 m/s and inlet temperature 20 degree Celsius. All the steam is condensed, the condensate is saturated water and temperature of cooling water at exit is 5 degree Celsius less than the condensate temperature. Assuming that overall coefficient of heat transfer is 4 k W/m2 degree, determine the mass of cooling water circulated
The lubricating oil for a large industrial gas turbine engine is cooled in a counter flow, concentric tube heat exchanger. The cooling water flows through the inner tube ( diameter = 25 mm) with inlet temperature 25 degree celsius and mass flow rate 0.2 kg/s. The oil flows through the annulus (diameter = 50 mm) with mass flow rate 0.125 kg/s and its temperature at entry and exit are 90 degree Celsius and 60 degree Celsius. Find outlet temperature of cooling water
Which of the following phrases (i),(ii), and (iii) given below each sentenceshould replace the phrase printed in boldletters to make the sentence grammaticallycorrect? Choose the best option among thefive given alternatives that reflect the correctuse of phrase in the context of thegrammatically correct sentence. If thesentence is correct as it is, mark (E) i.e., "Nocorrection required" as the answer.
Insurance is a contract, represented for apolicy, in which an individual or entityreceives financial protection.
i. Represented in a policy
ii. Represented by a policy
iii. Represented with a policy