Related Questions

When the TWC lies below the JHC at all discharges, the problem can be solved by which of the following provisions? i. Constructing a sloping apron above the river bed ii. Provision of roller bucket type of energy dissipator iii. Provision of a ski-jump bucket iv. A sloping apron below the river bed v. Construction of a subsidiary dam vi. A sloping apron partly above and partly below the river bed
Consider the following statements.
1. Magnetic lines of force are closed curves while electric lines are not.
2. Electric lines of force are closed curves while magnetic lines are not.
3. Both electric and magnetic lines of force are closed curves.
Which of statement(s) given above is/are correct?
The opening provided in sloping roof with its top parallel to the roof surface, is called
The live load for a sloping roof with slope 15°, where access is not provided to roof, is taken as
When the ground is sloping _____________ foundations are used to correct the levels of the sloping ground on which the building is to be constructed.
If in a purely competitive market with downward-sloping demand and upward sloping supply curves, a specific excise tax per unit of output is imposed, then
Assuming a downward-sloping demand curve and upward sloping supply curve, a higher equilibrium price may be caused by
Which of the following statement is true for the measurement of angle of V-groove using discs? Statement 1: This method is good for the measurement of the angle of machine tool sides. Statement 2: Discs should always touch the sloping sides of the groove.
Arrange the statements. Given statements refers to free-hand sketching of a circle. i) Add four radial lines between them. ii) Make the center and through it, draw horizontal and vertical center lines. iii) The paper may be revolved after about each quarter-circle for easy wrist motion while drawing. iv) Mark points on these lines at radius distance from the center.
Arrange the following stages in a sequence, such that they result in an ogee curve between two parallel lines AB and CD, such that they are the tangents to the arc. m) Join the adjacent ends B and C with a straight line. n) Divide the line BC into four parts using the points P1, P2, P3. o) Draw lines such that they pass through the points P1, P2, P3, and are perpendicular to the line BC. p) Draw the perpendicular lines through the points B and C such that they cut the lines passing through P1, P3 respectively at E and F. q) With the center E draw an arc BP2 and with center F draw an arc P2C, thus arc BP2C is required ogee curve.