Bissoy.com
Doctors Medicines MCQs Q&A

The ASCII code of 'A' is

The ASCII code of 'A' is Correct Answer 65

Hints: ASCII এর পূর্ণরূপ হলো America Standard Code for Information Interchange। এটি মাইক্রো বা পার্সোনাল কম্পিউটারের জন্য বহুল ব্যবহৃত ও বর্তমানে প্রচলিত কম্পিউটার কোড। A এর আসকি কোড ৬৫ এবং a এর আসকি কোড ৯৭।

Related Questions

The first 128 characters are the same in both the types of ASCII i.e. ASCII-7 and ASCII-8.
Which of the following command options are displayed when you use the Router# show frame-relay ? command?
1. dlci
2. neighbors
3. lmi
4. pvc
5. map
The most common binary code in use today is the 8 bit ASCII code. What do the letters ASCII stand for?
Computers use the seven-digit code called ASCII. What does ASCII stand for?
Which of the following statements is true with respect to ASCII? A. A programming language B. ASCII chart is not for decimals C. American Security Code for Information Interchange D. A character encoding scheme
Which of the following commands will display the current IP addressing and the layer 1 and 2 status of an interface?
1. show version
2. show protocols
3. show interfaces
4. show controllers
5. show ip interface
Which three commands can be used to check LAN connectivity problems on a router?
1. show interfaces
2. show ip route
3. tracert
4. ping
5. dns lookups
To enable EIGRP, which of the following would you use?
1. Router1(config-if)# ipv6 ospf 10 area 0.0.0.0
2. Router1(config-if)# ipv6 router rip 1
3. Router1(config)# ipv6 router eigrp 10
4. Router1(config-rtr)# no shutdown
5. Router1(config-if)# ipv6 eigrp 10
You need to allow one host to be permitted to attach dynamically to each switch interface. Which two commands must you configure on your catalyst switch to meet this policy?
1. Switch (config-if) # ip access-group 10
2. Switch (config-if) # switchport port-security maximum 1
3. Switch (config) # access-list 10 permit ip host 1
4. Switch (config-if) # switchport port-security violation shutdown
5. Switch (config) # mac-address-table secure
Which two of the following commands will place network 10.2.3.0/24 into area 0?
1. router eigrp 10
2. router ospf 10
3. network 10.0.0.0
4. network 10.2.3.0 0.0.0.255 area0
5. network 10.2.3.0 0.0.0.255 area 0