Designers usually include graphics to __________ a portion of screen.

Designers usually include graphics to __________ a portion of screen. Correct Answer Emphasize

The most important point the designers should keep in mind is that the graphics should not distract the user from his/her work. Thus the graphics should be simple enough to emphasize a portion of the screen, mainly the top left corner.
Bissoy MCQ

Related Questions

Designers usually include graphics to . . . . . . . . a portion of screen.
The size of the philips LCD television screen is given as the length of the screen's diagonal , Assume that the screens of the television were flat. Find out how many square inches greater would be the screen of square inches greater would be the screen of a square 21 -inch television set than that of a square 19-inch television set.
The size of the Philips LCD television screen is given as the length of the screen's diagonal, Assume that the screen of the television were flat, Find out how many square inches greater would be the screen of a square 21-inch television st than that of a square 19-inch television set
In the following figure, rectangle represents Web designers, circle represents Bloggers, triangle represents Photographers and square represents Cricketers. Which set of letters represents Web designers who are cricketers?
A 35mm wide slide with a 24mm×36mm picture is projected on a screen placed 12cm from the slide. The image of the slide picture on the screen measures 1m×1.5m. What is the linear magnification of the projector-screen arrangement?
The primary screen rejects could be as high as 50 percent, the primary screen rejects are often sent to a secondary screen to recover usable _________
A parallel beam of electrons of a given momentum pass through a screen S1 containing a slit and then produces a diffraction pattern on a screen S2 placed behind it. The width of the central maximum observed on the screen S2 can be increased by
A parallel beam of infrared radiation of wavelength of 1.01 × 10-6 m is incident normally on a screen with two slits 5 × 10-6 m apart and the resulting interference pattern is observed on a distant screen. What is the largest number of maxima that can be observed on the screen?
Higher is the mesh number, smaller will be the aperture size of the screen. It means that the aperture size of a 200 mesh screen will be smaller than that of 20 mesh screen. This is valid for
Base graphics are used most commonly for creating 2D graphics.