Related Questions

A cam should be designed only using uniform rise and fall within half of the cam, the remaining is dwell period, and without any dwell period in between the rise -fall periods and rise and fall periods should be same. The maximum rise in follower is 30 mm. How much the follower will rise when the follower is 120 degrees from its initial position of a cam?
A cam should be designed only using uniform rise and fall within half of the cam, the remaining is dwell period, and without any dwell period in between the rise-fall periods and rise and fall periods should be same. The maximum rise in follower is 45 mm. How much the follower will rise when the follower is 45 degrees from its initial position of a cam?
A cam should be designed only using uniform rise and fall within the second half of cam profile, the first half is dwell period, without any dwell period in between the rise and fall periods and rise and fall periods should be same. The maximum rise in follower is 45 mm. How much the follower will rise when the follower is 120 degrees from its initial position of a cam?
A cam should be designed only using uniform rise and fall within the second half of cam profile, the first half is dwell period, without any dwell period in between the rise and fall periods and rise and fall periods should be same. The maximum rise in follower is 55 mm. How much the follower will rise when the follower is 240 degrees from its initial position of a cam?
A cam should be designed only using uniform rise and fall within first half of cam profile, the remaining is dwell period, and without any dwell period in between the rise-fall periods and rise and fall periods should be same. The maximum rise in follower is 35 mm. How much the follower will rise when the follower is 240 degrees from its initial position of a cam?
A cam should be designed only using uniform rise and fall throughout the cam without any dwell period and rise and fall periods should be same. The follower is making a rise of 40 mm when the shaft is rotated to an angle of 150 degrees. What is the maximum rise in a follower?
A cam should be designed only using uniform rise and fall throughout the cam, without any dwell period and rise and fall periods should be same. The maximum rise in follower is 50 mm. How much the follower will rise when the shaft is rotated to an angle of 120 degrees?
Consider the following statements: 1. The delay time is the time required to reach 50% of the final value in the first time. 2. The rise time is the time required for the response to rise from 10% to 90% of its final value for underdamped systems. 3. The rise time is the time required for the response to rise from 0 to 100% for the underdamped systems. Which of these statements are correct?
Consider the following statements and choose the correct answer:
1. A direct proportionality exists between vapour pressure and the concentration of water vapour in the atmosphere
2. Relative humidity is an expression of the ratio of the actual vapour pressure of the atmosphere when saturated at the same temperature
3. A rise or fall in temperature with no change in vapour pressure will cause a drop or rise, respectively, in relative humidity
4. A rise or fall in vapour pressure with no change in temperature will be accompanied by a rise or fall, respectively, in relative humidity
To constitute a matter of res judicata which of the following conditions must concur?
1. The matter directly and substantially in issue in the subsequent suit or issue must be the same matter which was directly and substantially in issue either actually (section 11, explanation III) or constructively (section 11, explanation IV) in the former suit
2. The former suit must have been a suit between the same parties under whom they or any of them claim. Explanation VI of Section 11 must be read with this condition
3. The parties as aforesaid must have litigated under the same title in the former suit
4. The court which decided the former suit must have been a court competent to try the subsequent suit of the suit in which such issue has been subsequently raised. Explanation II of section 11 is to be read with condition
5. The matter directly and substantially in issue in the subsequent suit must have been heard and finally decided by the court in the first suit. Explanation V of section 11 is to be read with this condition