The heat transfer coefficient for rising film and falling film evaporators is same because they can be used in the same setup.

The heat transfer coefficient for rising film and falling film evaporators is same because they can be used in the same setup. Correct Answer False

The setup of rising film and falling film might be the same but the film orientation is different for both the setups and hence the heat transfer coefficients too.
Bissoy MCQ

Related Questions

Are these statements about the gasketed plate-and-frame evaporators true? Statement 1: Gasketed plate-and-frame evaporators are not used for heat sensitive materials. Statement 2: These systems are operated as rising-film, falling-film evaporators.
The applications of falling film and rising film are more or less same, but if industries have the cost capital, they go for falling film, why?
Falling film evaporators are considered over climbing film evaporators because of which one of the following factor?
Experimental results indicate that the local heat transfer coefficient h g for flow over a flat plate with an extremely rough surface is approximated by the relation h x = a x -0.12 Where a is a constant coefficient and x is distance from the leading edge of the plate. What is the relation between this local heat transfer coefficient and the average heat transfer coefficient for a plate of length x?
We have a triple effect evaporator which has steam supply of 5kg/hr, the setup is a forward pass setup, feed enters the 1st setup at 10kg/hr of 50% concentration and leaves the final effect at 75% concentration. What is the product discharged from this setup?
We have a triple effect evaporator which has steam supply of 5kg/hr, the setup is a forward pass setup, the feed enters the 1st setup at 10kg/hr of 50% concentration and leaves the final effect at 75% concentration. What is the economy of this setup?
The residence time of agitated film evaporators is ______ than rising film evaporators.
Climbing film evaporators are _________ falling film evaporators.
A stream of air at 100 kPa pressure and 300 K is flowing on the top surface of a thin flat sheet of solid naphthalene of length 0.2 m with a velocity of 20 m/sec. The other data are: Mass diffusivity of naphthalene vapor in air = 6 * 10 –6 m2/sec Kinematic viscosity of air = 1.5 * 10 –5 m2.sc Concentration of naphthalene at the air-solid naphthalene interface = 1 * 10 – 5 kmol/m3 Calculate the overage mass transfer coefficient over the flat plate. Note: For heat transfer over a flat plate, convective heat transfer coefficient for laminar flow can be calculated by the equation. Nu = 0.664 ReL1/2 Pr1/3 you may use analogy between mass and heat transfer.
What controls the overall heat transfer coefficient in falling film evaporators?