Related Questions

As per the Indian boiler regulation (IBR), the type of joint preferred for the circumferential joint is the __________ joint.
A Butt
B Lap
C Welded
D None of these
In walking, the hip bone is suspended by the following muscles acting on the supported side of the body
A Gluteus minimus
B Gluteus medius
C Gluteus maximus
D Obturator externus
E Obturator internus
According to I.B.R., the distance between the rows of rivets, for equal number of rivets in more than one row for lap joint or butt joint (chain riveting) shall not be less than
A d
B 1.5 d
C 2 d
D 2.5 d
For longitudinal joint in boilers, the type of joint used is
A Butt joint with single cover plate
B Butt joint with double cover plate
C Lap joint with one ring overlapping the other
D Any one of the above
For circumferential joint in boilers, the type of joint used is
A Butt joint with single cover plate
B Butt joint with double cover plate
C Lap joint with one ring overlapping the other
D Any one of the above
A welded joint as compared to a riveted joint has __________ strength.
A Same
B Less
C More
D None of these
When the rail ends rest on a joint sleeper, the joint is termed as
A supported rail joint
B suspended rail joint
C bridge joint
D base joint
Joint cost allocation method, in which individual product from joint products must gain a gross margin percentage is classified as
A sales value at split off method
B joint products value at split off method
C constant gross margin percentage NRV method
D Gross realizable value method
Method which allocates joint costs of joint products, considering physical measures such as volume or relative weight at point of split off is known as
A direct cost measure method
B indirect cost measure method
C physical-measure method
D relative-measure method
If d is the normal diameter of a bolt in mm, then the initial tension in kg in a bolt used for making a fluid tight joint as for steam engine cover joint is calculated by the relation
A 124 d
B 138 d
C 151 d
D 168 d

Next steps