Which of the following Excel screen components can NOT be turned on or off?

Which of the following Excel screen components can NOT be turned on or off? Correct Answer None of these

The following Excel screen components can be turned on or off - a) Formula Bar b) Status Bar c) Tool Bar
Bissoy MCQ

Related Questions

Two pipes A and B can fill an empty cistern in 18 and 27 hours, respectively. Pipe C can drain the entire cistern in 45 hours when no other pipe is in operation. Initially, when the cistern was empty Pipe A and Pipe C were turned on. After a few Pipe A was turned off and Pipe B was turned on instantly. In all, it took 55 hours to fill the cistern. For how many hours was Pipe B turned on?
A small and medium enterprise imports two components A and B from Taiwan and China respectively and assembles them with other components to form a toy. Components A contributes to 10% of production cost while components B contributes to 20% of production cost. Usually the company sells this toy at 20% above the production cost. Due to increase in the raw material and labour cost in both the countries ,component A became 20% costlier and components B became 40% costlier. Owing to these reasons the company increased its selling price by 15%. Considering that cost of other components does not change. What will be the profit percentage if the toy is sold at the new price?
The size of the philips LCD television screen is given as the length of the screen's diagonal , Assume that the screens of the television were flat. Find out how many square inches greater would be the screen of square inches greater would be the screen of a square 21 -inch television set than that of a square 19-inch television set.
The size of the Philips LCD television screen is given as the length of the screen's diagonal, Assume that the screen of the television were flat, Find out how many square inches greater would be the screen of a square 21-inch television st than that of a square 19-inch television set
Mark the incorrect proposition:
1. Set-off is a statutory defence to a plaintiff's action, whereas a counterclaim is a cross-action.
2. Set-off and counter-claim arises out of the same transaction.
3. Set-off should not be barred on the date of the suit while counter-claim should not be barred on the date of filing of written statement.
4. Claim for set-off cannot exceed plaintiff's claim, whereas counterclaim can exceed the plaintiffs claim.
5. Both set-off and counter-claim cannot exceed the pecuniary jurisdiction of the court.
A parallel beam of electrons of a given momentum pass through a screen S1 containing a slit and then produces a diffraction pattern on a screen S2 placed behind it. The width of the central maximum observed on the screen S2 can be increased by
A parallel beam of infrared radiation of wavelength of 1.01 × 10-6 m is incident normally on a screen with two slits 5 × 10-6 m apart and the resulting interference pattern is observed on a distant screen. What is the largest number of maxima that can be observed on the screen?
A 35mm wide slide with a 24mm×36mm picture is projected on a screen placed 12cm from the slide. The image of the slide picture on the screen measures 1m×1.5m. What is the linear magnification of the projector-screen arrangement?
The primary screen rejects could be as high as 50 percent, the primary screen rejects are often sent to a secondary screen to recover usable _________
Higher is the mesh number, smaller will be the aperture size of the screen. It means that the aperture size of a 200 mesh screen will be smaller than that of 20 mesh screen. This is valid for