Test my Merit My Results Create Exam

Higher Study | Design of Steel Structures

Structural Fasteners
Which of the following statement is correct for reducing web buckling due to diagonal compression?
For a compression member with double angle section, which of the following section will give larger value of minimum radius of gyration?
Which of the following sections should preferably be used at places where torsion occurs?
Which of the following types of riveted joint is free from bending stresses?
Bending compressive and tensile stresses respectively are calculated based on
A steel beam supporting loads from the floor slab as well as from wall is termed as
If the cost of purlins/unit area is p and the cost of roof covering/unit area is r, then cost of trusses/unit area for an economical spacing of the roof trusses will be
The effective height of a column of height H restrained fully at its top and partially at bottom is 
A square of side a is placed such that its diagonal is horizontal. The shape factor of the square will be
Maximum size of a fillet weld for a plate of square edge is
The failure of column depends upon
The structure made of rigid curved surface are known as
Given that: Ae = effective area of the member and σy = yield stress In order to obtain the ultimate strength of a tension member, as per the plastic design concept, Aeσy is to be multiplied by
As per elastic theory of design, the factor of safety is the ratio of 
A reduction in the allowable stress in steel chimney construction is necessary if the temperature exceeds
Ads