Test my Merit My Results Create Exam

Higher Study | Analog Electronics | Oscillators and Feedback Amplifier

The purpose of an amplifier is:
The only drawback of using negative feedback in amplifiers is that it involves:
An electronic oscillator is:
Large Signal Amplifier is also known as
A signal Vmsin (ωt + φ) is applied to an amplifier whose gain A is independent of frequency. The amplifier will preserve the form of the input signal (though with a delay) if the phase shift φ is:
Which one is increased when a negative feedback voltage is applied to an amplifier?
In the feedback network shown below, if the feedback factor k is increased, then the
A circuit using op-amp shown below has
The amplifier circuit shown in the figure is an example of
The feedback topology in the amplifier circuit (the base bias circuit is not shown for simplicity) in the figure is
What do phase-shift oscillators, twin-T oscillators, and Wien bridge oscillators have in common? a. They use RC frequency control b. They have a sinusoidal output. c. They use amplifier gain to overcome feedback loss.
What suits best for a Hartley oscillator circuit?
In an oscillator circuit, 5% of the output is fed back positively to the input. What is the minimum gain required for oscillations to occur? (Assume that proper phase-shift is achieved)
What would be the computational value of feedback voltage in a negative feedback amplifier with A = 100, β = 0.03 and input signal voltage = 30 mV?
A signal source of internal resistance 1.2 kΩ is connected to the input of an amplifier with a voltage gain of 140. What is the value of input resistance the amplifier should have to get an overall gain of 100?
Ads